Table of Contents
Advertisement
The DMP-CD100 is equipped with battery recharging circuitry. For safety
measures, it requires specifically made NICAD (Nickel-Cadmium) batteries.
Use ONLY the following rechargeable battery types: KENWOOD NB-77 /
NB-88, PANASONIC RP-BP60D, SONY NH-DM2AA or equivalent.
NOTE: It is always a good idea to let Nickel-Cadmium batteries run all the
way down before charging them. When you do charge them, do so to their
full potential and they will last longer and provide more power.
ALKALINE BATTERY INSTALLATION
Insert two AA batteries into the battery compartment on the bottom of the
DMP-CD100. Be sure to observe the proper polarity (The "+" and "-" signs,
as indicated inside the battery compartment).
NOTE:
When replacing the alkaline batteries, use two new batteries of the same
type.
When inserting the batteries, mistakenly inserting even one with
improper polarity will cause leakage.
BATTERY REPLACEMENT
If the rechargeable nickel-cadmium battery or the alkaline batteries are below
2.1v, the battery- low indicator will be shown on the display.
Recharge the rechargeable nickel-cadmium battery or replace the alkaline
batteries before using the DMP-CD100.
3
Advertisement
Table of Contents
