Do you have a question about the Crucial CT51264BF160BJ and is the answer not in the manual?
Questions and answers
Subscribe to Our Youtube Channel
Summary of Contents for Micron Crucial CT51264BF160BJ
Page 1
MacBook Core 2 Duo RAM Installation Difficulty Easy Steps Time Required 00:05:00 Sections...
Page 2
Battery 2 steps Memory Cover 2 steps RAM Installation 1 step Flags Introduction Accessing the RAM in this computer is straightforward and requires minimal disassembly. The Mid 2009 2.13 GHz model is the only A1181 MacBook that uses PC2-6400 RAM. Tools ...
Page 3
RAM Upgrade Kit For sale from another site Step 1 Battery Use a coin to rotate the battery-locking screw 90 degrees clockwise. Add Comment Bold (ctrl+b)
Page 4
Italic (ctrl+i) Insert a link (ctrl+k) Insert a quote Undo (ctrl+z) Redo (ctrl+⇧z) Step 2 Lift the battery out of the computer. Add Comment Bold (ctrl+b) Italic (ctrl+i) Insert a link (ctrl+k) Insert a quote Undo (ctrl+z)
Redo (ctrl+⇧z) Step 3 Memory Cover Unscrew the three evenly-spaced Phillips screws from along the rear wall of the battery compartment. The screws are captive to the metal memory cover so you cannot lose them. Add Comment Bold (ctrl+b) Italic (ctrl+i)
Page 6
Step 4 Rotate the L-shaped memory cover so it clears the battery compartment opening and lift it up and out of the computer. Add Comment Bold (ctrl+b) Italic (ctrl+i) Insert a link (ctrl+k) Insert a quote Undo (ctrl+z) Redo (ctrl+⇧z)
Step 5 RAM Installation Pull back on the metal lever and slide the RAM chip out from its compartment. Unlike the iBook line, the MacBook has two RAM slots. When installing RAM, be sure to push the chips in firmly or else the computer will not register them.
Page 8
Comments: 0 Favorites: 0 Difficulty Easy Steps Time Required Suggest a time?? Sections Lower Case 2 steps Battery 2 steps...
Page 9
RAM Installation 2 steps Flags Introduction Upgrade your RAM for a noticeable increase in speed. Tools Phillips #00 Screwdriver Available for sale on Crucial Spudger Available for sale on Crucial Parts RAM Upgrade Kit...
For sale from another site Step 1 Lower Case Remove the following ten screws: Three 14.4 mm Phillips screws Three 3.5 mm Phillips screws Four 3.5 mm shouldered Phillips screws Add Comment Bold (ctrl+b) Italic (ctrl+i) Insert a link (ctrl+k) Insert a quote Undo (ctrl+z) Redo (ctrl+⇧z)
Page 15
Use your fingers to pry the lower case away from the body of the MacBook near the vent. Remove the lower case. Add Comment Bold (ctrl+b) Italic (ctrl+i) Insert a link (ctrl+k) Insert a quote Undo (ctrl+z) Redo (ctrl+⇧z) ...
Page 19
Use the edge of a spudger to pry the battery connector upwards from its socket on the logic board. It is useful to pry upward on both short sides of the connector to "walk" it out of its socket.
Page 20
Bend the battery cable slightly away from its socket on the logic board so it does not accidentally connect itself while you work. Add Comment Bold (ctrl+b) Italic (ctrl+i) Insert a link (ctrl+k) Insert a quote Undo (ctrl+z) Redo (ctrl+⇧z) ...
Page 24
Pull the two RAM retaining arms away from the center of the RAM module. The RAM module should "pop" up slightly from its socket.
Need help?
Do you have a question about the Crucial CT51264BF160BJ and is the answer not in the manual?
Questions and answers