Optoelectronics CD200 User Manual

OPTOELECTRONICS,
INC
cD200 Frequency counter / Decoder user Guide
BATTERY/POWER
The cD20o is equipped with a built in 3.7V Li-lon Battery. The cD2o0 may require charging before use.
The
included power supply with cable charges the battery connecting at the port on the top of the unit. (NoTE:
The cD200 does NoT
have function to connect to a PC and this port is oNLY for charging the battery/powering
the unit). when power adaptor is
connected the red LED will light to indicate battery charging and when charging complete, green LED will light
to indicate charging
complete. CD200 can be used while connected to power adaptor and charging. The battery level indicator at
top left of LCD
display will indicate remaining battery level while in use. The CD200 has an auto power off function that will
allow power off in a
selectable time range.
BUTTONS cD200 has 4 Function Buttons below LCD display to operate unit
BLACK - F1 WHITE IEFT. F2
WHITE CENTER - F3 WHITE RIGHT. F4
POWER ON/OFF Press F1 for 2 seconds to power on/Press F1 for 4 seconds to power off
QUIcK SrART/BEGIN
OPERATION 4 Main Screen Function options MENU/sTART/ANALoG-D1G;rAL/CLR/ATTENUATtoN
MENU/FI Press to access Set Up Menu
START/F2 Press to Start Frequency/Code
detection
ANAIOG-DIGITAL
Press F3 to toggle select between Analog/Digital
(DMR Radio only) Frequency detection
CLR Press F4 to clear Frequency/Codes
from display
ATTENUATION
SWITCH Top of Unit - Select either Odb or lOdb Signal Attenuation
MENU - Basic Menu Options
Press Fl to enter MENU options FREQ METER/SYSTEM/PoWER
}FFIAB}UTIANALoG-DIGITAL
ln Basic Menu Use F3 to scrolldown / F4 to scroll up / F2 to make selection / Fj. powers Off
FREQ METER Press F2 returns to home screen counter/Decoder mode
SYSTEM Press F2 enters unit SET Up mode screen
POWER OFF Press F2 for instant power Off
ABOUT Press F2 for information on Unit
ANATOG-D|G|TAI
Press F2 to select either Analog or Digital (DMR Radio only) Frequency detection
SYSTEM SET UP
From Main Screen press F1 to enter MENU, scroll using F3 or F4 to SYSTEM and use F2 to select