Advertisement
Quick Links
Instruction manual
FLM – Tripod serie
CP-30 M4 II / CP-34 M4 II
your specialist retailer:
mk-messtechnik GmbH
division FLM-Products
Zeppelinstraße 1
73274 Notzingen
Germany
Tel.: +49 (0) 70 21-92 80 7 - 53
Fax: +49 (0) 70 21-95 66 92 6
Internet: www.flm-gmbh.com
email: flm@mk-messtechnik.de
Advertisement
Related Manuals for FLM CP-30 M4 II
Summary of Contents for FLM CP-30 M4 II
- Page 1 Instruction manual FLM – Tripod serie CP-30 M4 II / CP-34 M4 II your specialist retailer: mk-messtechnik GmbH division FLM-Products Zeppelinstraße 1 73274 Notzingen Germany Tel.: +49 (0) 70 21-92 80 7 - 53 Fax: +49 (0) 70 21-95 66 92 6 Internet: www.flm-gmbh.com...
-
Page 2: General Information
Thank you for purchasing one of our tripods. You have purchased a high-quality piece of equipment for your photography equipment or your photo studio. Your new FLM tri- pod will surely accompany you for many years and will always be at your side. This is guaranteed by the high quality standards that FLM itself sets for its products. - Page 3 Change rubber feet / spikes Changing between hardened steel tip and rubber base is very easy, fast and trouble-free with the FLM tripods of the CP-30 and CP-34 series. By onscrewing or unscrewing the rubber cap, the spike is exposed or covered again. By turning the rubber cap to the left, the spike is exposed (picture 1).
- Page 4 Automatic foot-locking system Thanks to the automatic locking system, the FLM tripod can be folded and unfolded in just a few steps. Two locking positions are available. Pos. 1 is available immediately after unfolding the tripod legs.
- Page 5 Load hook The tripod can be weighted down with ballast to give it more stability and pre- vent it from falling over. The camera backpack/bag can be used as ballast. This is hooked into the hole in the shoul- der screw connection or on the HB-75/ HB-100 under the tripod shoulder using the snap hook provided.
- Page 6 Maintenance of the clamping mechanism of the tripod legs The tripod legs consist of several segments so that the tripod can be pushed together to a small packing size. Therefore the individual segments need a clamping mechanism so that the legs can be secured in the desired position after the segments have been pulled out.
-
Page 7: Technical Datas
into itself at this point, if possible. Then move the insert into the clamping sleeve and insert the free part into the groove. Then press the insert more and more into the groove until the insert is completely snapped into the groove. Please carry out this procedure very carefully, as the plastic insert can break if bent too much. - Page 8 Standard-/Quick release bases SRB-60 QRB-70 mk-messtechnik GmbH | Division FLM products | Zeppelinstr. 1 | 73274 Notzingen / Germany Tel.: +49 (0) 70 21-92 80 7 - 53 | Fax: +49 (0) 70 21-95 66 92 6 www.flm-gmbh.com | flm@mk-messtechnik.de...
Need help?
Do you have a question about the CP-30 M4 II and is the answer not in the manual?
Questions and answers