EUROCHILL MediGuard MG315 Manual

READ THIS BEFORE PLUGGING IN UNIT
Congratulations on choosing a MediGuard Medical Refrigerator. This set of instructions will
show you how to properly install and set up your unit to ensure optimal performance. Failure
to follow these instructions may result in a Service Charge if a technician needs to attend. If
you require any assistance, please contact us on 1300 459 140.
• Remove all packaging and wrap from the Unit
• Check for any damage to the unit. Report any damage immediately to 1300 459 140
• INSIDE THE UNIT:
• Keep the unit on a firm, flat and even surface. Do not place the unit in direct sunlight or near heat
sources. Ensure the room has adequate ventilation.
• Leave a minimum of 10cm around the Unit for ventilation and heat dissipation.
• DO NOT place items on the shelves in such a way that the entire surface area is covered. This will
lead to restricted airflow and reduce the efficiency and effectiveness of the Unit. A recommendation
of ¾ maximum usage of the width, height and depth
• START-UP: Once in position and levelled, plug in the unit to a normal GPO (General Power Outlet).
• On initial start-up, depending on the ambient temperature, the Unit may temporarily go into 'Hi-
Temp' Alarm Mode.
- To silence the Alarm, press
SHELVES
2 x Keys
will allow the unit to function properly.
MediGuard
RANGE
MG315