SoundWater V75 Instructions

Only Excellence
V75 Battery Pack
Instructions
The V75 USB Battery Pack
continuous power to the Orcas
Flowmeter. To charge your device,
simply plug into either of USB
outputs. These battery packs can
recharge via any USB port or from
a solar panel. Battery packs can be
charged while charging your device.
The interior of a solar charger case
can become hot in the sun.
In hot conditions, open the battery
compartment to increase air flow
and avoid overheating.
5 4
1
1
Power Level Button
2
Power Level Indicator
3
MicroUSB Input
4
USB C Input
5
USB Output 1
6
USB Output 2
7
MicroUSB Charging Cable
SoundWater Technologies, LLC :: 1-509-899-7838 :: soundwatertech.com
Charging Your Orcas Flowmeter
supplies
Using your Orcas Flowmeter's USB
charging cable, plug directly into either
of the two (2) USB Outputs. Device will
automatically begin to charge and supply
power.
Battery features Always-On technology
and will not shut off. To stop charging
your Orcas flowmeter, double tap the
Power Level Button or disconnect from
the battery. To resume charging, tap the
Power Level Button once.
Remove cable(s) from USB Outputs
when storing the battery for an extended
period.
6
Charge Battery Pack from
USB or USB-C
Recharge the battery from any USB port
3
(with the included MicroUSB
Charging Cable). Can also be recharged
via USB-C using any USB Type C cable
(not included).
7
Battery Level Indicator
Press Power Level Button to show
charge level. LEDs will blink when
charging and indicate charge progress.
100% Full 75% Full 50% Full
Charge Time (Hours)
POWER SOURCE HOURS
USB (5V) 8
5W Solar Panel 18
10W Solar Panel 9
Tips for Faster Solar Charging
1. Place solar panel outside in direct
sunlight. Panel will not work inside.
Charge time increases on cloudy days.
2. Point panel directly at the sun, avoid
shading the panel.
3. Confirm LEDs on battery are lighting
up in sequence.
25% Full
(continues)
REV APR-10-24