Sigma 14337BR Installation Instructions

INS14337
LED Light
Improper wiring of any electrical device can cause serious injury or death. These wiring devices should only be installed by a
WARNING
certified electrician or other qualified person.
CAUTION This product should be installed in accordance with the National Electrical Code and all applicable local codes and standards.
TURN OFF POWER BEFORE INSTALLING.
INSTALLATION
1. Thread LED light head into weatherproof cover.
2. Connect the LED light wires to the supply line using wire nuts
(not included) per wiring diagram below.
Black LED Wire to
Black Supply Wire
Ground Supply Wire
to Grounding Screw
3. Mount the LED and tighten locknut to secure in place.
4. Adjust the lamp position using the instructions on the right
and seal threads with a silicone sealing compound (not included).
5. Seal all openings to comply with wet location installation.
Note - Modifications to the product void certifications and are not recommended as they may impact performance.
This long lasting LED requires no maintenance or bulb changes for the life of the lamp.
Installation Instructions
White LED Wire to
White Supply Wire
Power
Supply
INSTALLATION INSTRUCTIONS
ADJUSTING LAMP POSITION
1. Loosen knob on lamp.
2. Adjust lamp to desired position
using vertical movements.
3. Tighten knob to lock position.
4. For horizontal motion, loosen
locknut, rotate to the desired
position, tighten locknut to
lock postition.
Locknut
INS14337