Related Manuals for Kind KINDTS-1044
Summary of Contents for Kind KINDTS-1044
- Page 1 Smart Metered Tannin + Water Softener Installation / Operation Manual Model #: KINDTS-1044 KIND WATER kindwater.com Have questions? Call us: 888-614-5559 EDUCATION KINDTS-1044-REV-A-JU24...
-
Page 2: Table Of Contents
Master Programming............Page 20 Valve Body Assembly............Page 23 Bypass Assembly............... Page 25 Service Instructions............Page 26 Troubleshooting..............Page 29 Error Codes................ Page 31 Warranty Information............Page 32 Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •... - Page 3 Pipe dope and liquid thread sealers may contain a carrier that attacks some plastic materials. It is recommended that Teflon® tape be used to seal plastic Noryl® threaded fittings. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
-
Page 4: Softener Specifications
3. Rapid Rinse - The control valve directs the water flow downward, settling and recompacting the resin bed. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •... - Page 5 Pre-Installation Check List A Kind Water Test & Survey should always be performed in order to determine total water hardness (in gpg) and total dissolved iron (in parts per million - ppm). This is critical for proper equipment selection, sizing and for determining the program for regeneration frequency.
- Page 6 Installation Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
- Page 7 If using PVC or plastic pipe primers and solvent cements specifically recommended for use with potable water are required. • Do not “TEE” to the main drain line from control valve. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
- Page 8 Where the drain line is elevated above the control valve or exceeds 20 feet in NOTE KIND WATER length, 3/4” I.D. drain line tubing should be used. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation • EDUCATION...
- Page 9 Do not plug into an outlet controlled by a wall switch or pull chain that could NOTE inadvertently be turned off Electronic Connections Power Supply Powered in Backwash Step Only P B S (Cycle #1) Powered for Entire Regen. Cycle Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
-
Page 10: Utilizing Bluetooth
If the valve you want to connect to doesn’t show up, or there is a problem connecting to a device you can press the “Scan for Devices” button or the Kind Water logo at any time to refresh the list and start the process over. - Page 11 From the Dashboard, all items in GREEN can be changed, while blue fields are informational only. If you are unsure about the function of the field click the for more information. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
- Page 12 If you have a filter and a softener the valves should be set to NOTE regenerate at different times. Factory default times are 12a.m. for filters, and 2 a.m. for softeners. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
- Page 13 Status and History From the Status and History, all items in GREEN can be reset. Touch any table to explode a detailed list of the last 60 days. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
-
Page 14: Programming The Control Valve
NOTE capacity charts. Do not reduce salt settings below 9 lbs. as the water level in the brine tank will CAUTION not reach the grid plate. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •... - Page 15 3 seconds. Stay in (step 2- Brine draw) for an additional 10 minutes and verify all water has been drawn out of the brine tank. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
- Page 16 • Servicing the water softener. • A water leak from the water softener is evident. • Shock treating water well and piping with chlorine or other disinfectant. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
- Page 17 • Inspect and clean the brine tank when sediment appears in the bottom of the salt compartment. • Always keep the brine tank supplied with good quality salt, a type designed for use in water softeners. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
- Page 18 The display is turned off to conserve battery power during this time. To confirm that the battery is working, press either button and the display will turn on for five (5) seconds. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
- Page 19 (Repeat until valve returns to the home display) Softeners Default (Min) Step 1 Backwash Step 2 Brine & Rinse Step 3 Rapid Rinse Step 4 Brine Refill 9 lbs/ cu ft Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
- Page 20 • The number of minutes allotted for the selected backwash step is displayed on the far right. • Change the digit values using the Set/Change and Menu/Enter buttons as described above. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
-
Page 21: Master Programming
To Exit the Master Programming Mode, press the Menu/Enter button until time of day returns. If no buttons are pressed for 60 seconds, the Master Programming Mode will be NOTE exited automatically. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •... - Page 22 6 X 1/2” Slotted, Hex Head Blk 6 X 1/2 Fenderwasher SST 20001X002 Washer Circuit Board 20111X014 6-32 X 5/16” Phillips, Pan Head 10-24 X 3/4” Screw SST 20001X001 Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
-
Page 23: Valve Body Assembly
Valve Body Assembly Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •... - Page 24 Injector Cap 20001X223 Injector Cap Seal 20001X224 Injector, White 20017x219 Injector, Blue 20017x220 Injection Screen 20001X222 Plug 20001X217 Tank. O-Ring 20015X043 Dist. O-Ring 20561X204 Meter Assembly 20017X203 Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
-
Page 25: Bypass Assembly
Bypass Assembly Description Part # D15 Bypass (included with all units) 20017X283 1” NPT Elbow Set (included with all units) 20017X284 Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •... -
Page 26: Service Instructions
5. Remove piston retaining plate screws. 6. Pull upward on end of piston yoke until assembly is out of valve. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •... - Page 27 3. Unscrew meter assembly nut from valve body. 4. Remove meter from valve body and clean or replace as necessary. 5. Reinstall meter, nut and cable. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
- Page 28 Call Kind Water’s Technical Support at 833-390-2959. Check for correct bed depth. Broken Resin loss distributor tube. Air or gas in bed: well gas eliminator. Loose brine line. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
-
Page 29: Troubleshooting
Salty Water to Service Increase pressure to allow injector to Low inlet pressure perform properly. (20 psi minimum) Excessive brine refill cycle time Lower brine refill time. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •... - Page 30 Drain Same as above. rapid rinse position Check for jammed piston. Replace Motor stopped or jammed piston and seals. Replace motor if motor is unresponsive. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
-
Page 31: Error Codes
Either way, proceed to the next step. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •... - Page 32 • The power supply has come unplugged from the control valve • The power supply is not working Water Treatment Equipment For all Warranty information please visit www.kindwater.com/storepolicy/. Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
- Page 33 Warranty Kind Water Systems - Smart Metered Tannin + Water Softener Installation and Operation •...
Need help?
Do you have a question about the KINDTS-1044 and is the answer not in the manual?
Questions and answers