enLighten enLink-Exit-SC Installation Instructions

SuperNova
enLink-Exit-SC
LED Floodlight with Specialised Optics
Installation Instructions
NOTE: All electrical work must be carried out by a licensed electrician as per the latest AS 3000 wiring regulations.
WARNING: All maintenance is to be performed by the supplier, a service agent or qualified person.
The luminaire must be operated within its specified operating parameters and in accordance with our warranty requirements.
Note: Regularly discharging the batteries (e.g during construction stage) will significantly shorten the battery's lifespan.
Product failure as a result of this is strictly NOT COVERED UNDER WARRANTY.
These documents are available on our website
INSTALLATION
1.
Remove the mounting
bracket by inserting
a screwdriver into the
locking tab
5.
Slide the fitting into
the mounting bracket
by holding the unit
horizontal to parallel with
the bracket. Ensure the
metal lugs line up
INITIAL LED INDICATORS
Applicable first 24hrs only
Status Charge Indicator
White LED on Red LED on
White LED on Green LED on
White LED on Red LED flashing
LED off LED off
Exit Sign
2.
Place the mounting
bracket at the ceiling/wall
location, allowing 50mm
on each side for its sliding
mechanism. Mark the
position of the screw holes
and cable entry through
the bracket
6.
Fit the side of the fitting
into the slot of the
bracket first, then slide
the unit in until it locks
Battery charging
Battery fully charged
Battery not detected
Power not detected
3.
Remove the bracket to
show the hole markings.
Drill mounting holes and
a 20mm hole for the cable
entry
7.
Decals can be fitted by
gently inserting the tabs
into the 6 slots under the
diffuser
www.enlighten.com.au |
4.
Feed the cables through
the holes of the mounting
bracket, secure bracket
to surface and connect
the cables to the terminal
block
8.
After installation, this
fitting is now a fully
operational emergency
light, please check
indicators on the side
of the fitting.
Subject to change
June 2024
1800 365 444