SunTech SM-47-4073L7 Manual

SM-47-4073L7 1" IMPACTWRENCH
7" Extended Anvil / Twin Hammer
Actual product may be slight different from the product described herein.
Tool Specification:
Square Drive:
Free Speed:
Maximum Torque:
Working Torque Range:
Air Inlet:
Hose Size:
Air Pressure:
Average Air Consumption: 10 CFM (282 L/Min)
SAFETY RULES
READ, UNDERSTAND AND KEEP THESE INSTRUCTIONS,
WARNING Failure to follow all instructions listed below may result in serious injury.
WORK AREA HAZARD & PERSONAL SAFETY
1. Keep your work area clean and well lit.
2. Do not operate power tools in explosive atmospheres, such as in the presence of
combustible liquid, gases or dust. Power tool create sparks which may kindle the
dust or fumes.
3. Disconnect tool before performing service or when not in use.
4. High sound levels can cause permanent hearing loss. Use hearing protection
during operation.
5. Maintain a balanced body position and secure footing.
6. Slip/Trip/Fall is a major cause of serious injury or death. Be aware of excess hose
left on the walking or work ground.
7. Repetitive work motions, awkward positions and exposure to vibration can be
harmful to hands and arms. If numbness, tingling, pain or whitening of the skin
occurs, stop using the tool and consult a physician.
8. Always wear impact-resistant eye and face protection when operating the tool or
near the operation, repairing, maintaining the tool or changing accessories on the
tool.
TOOL USE AND CARE
1. Use support handle or other practical ways to secure and support the work piece to
a stable platform.
2. Do not force the tool. Use the correct tool for your application. The correct tool can
do the job better and more secure at the rate of tool designed.
To prevent serious injury, read and understand
all warning and instructions before use.
1" (25.4 mm)
6,000 RPM
1,800 ft-lbs (2,441 Nm)
200 ~1,500 ft-lbs (271~2,033 Nm)
1/2"
1/2" I.D. (13 mm)
90 P.S.I. (6.2 Bar)