Advertisement
Troubleshooting Guide
SYMPTOM
The iPod does not play or respond to
commands from the receiver's remote.
The blue LED under The Bridge goes out
when the receiver is in the Standby mode.
The iPod's front-panel display and controls
do not operate when the iPod is docked in
The Bridge and DMP/The Bridge is selected
as the receiver's input.
Specifications:
iPod Compatibility: All iPod "docking connector" models, including third-generation and later Click Wheel iPods, iPod photo
(audio playback only) and iPod mini. Not compatible with iPod shuffle
Receiver Compatibility: All Harman Kardon products with The Bridge logo on the carton and owner's manual.
Dimensions (H x W x D): 1-3/16" x 4-1/2" x 4-1/2"
Weight: 5.9 oz.
© 2005 Harman International Industries, Incorporated. All rights reserved.
Harman Kardon and Harman International are trademarks of Harman International Industries, Incorporated,
registered in the United States and/or other countries.
The Bridge is a trademark of Harman International Industries, Incorporated.
iPod is a registered trademark, and Shuffle is a trademark, of Apple Computer, Inc.
SOLUTION
• Make sure that The Bridge is properly connected
to a compatible Harman Kardon receiver.
• Make sure that DMP/The Bridge is selected as the input
on the receiver.
• Check the menu setting for DMP on your receiver to make
sure that the "RECHARGE IN ST-BY" option is
turned ON, if available.
• Make certain that the receiver is in the Standby mode by looking for
the amber standby light. The iPod will not charge when the Master
Power Switch is off.
• This is normal and does not indicate a problem
with the iPod, The Bridge or your receiver.
™
. iPod not included.
5
Advertisement
