Download Print this page

Harman Kardon CITATION 12D Supplement Sheet

Solid state amplifier

Advertisement

Quick Links

harman/ kardon
55 AMES COLIRT, PLAINVIEW, N. Y. 1 1 803
CITATION TWELVE DELUXE
Your Citation Twelve installation and operational manual i s to be modified, as follows:
1.
Page
2
"Citation Warranty"
Paragraph
2
i s modified to read:
"The Citation warranty does not include repair or replacement of the wooden enclosure due
to damage incurred after initial delivery or transportation charges to and from the factory or
an authorized warranty station."
2.
Page
3
"Power Requirements"
Revise item
3
to read:
Locate black and brown wires attached to fuse post. Unsolder brown wire only. On left
channel remove 1650 ohm
10
watt resistor. Black wire remains on fuse post.
Revise item 5 to read:
Join the black/white wire you have just removed, with the brown wire removed in step
3
and
solder together to the vacant lug provided on the lug strip. O n left channel, solder the 1650
ohm
10
watt resistor to this lug.
3.
Inside Rear Cover
Replace diagram with rear panel diagram shown below.
RIGHT OUTPUT
J
L
PREAMPLIFIER

Advertisement

loading

Summary of Contents for Harman Kardon CITATION 12D

  • Page 1 Revise item 5 to read: Join the black/white wire you have just removed, with the brown wire removed in step solder together to the vacant lug provided on the lug strip. O n left channel, solder the 1650 watt resistor to this lug.
  • Page 2 200 Watts 2.0 AMP ' T he speaker fuse should be in the positive speaker line and located at or near the speaker input terminals. It should NOT be located at the amplifier speaker terminals. The fuse and fuse holder can be obtained at any electronic supply store. You may use either an in-line or block type fuse, as shown in the drawing below.

This manual is also suitable for:

Citation twelve deluxe