TP-Link Aginet XZ000-G7 Quick Installation Manual

Quick Installation Guide
1-Port Gigabit XPON Terminal
©2023 TP-Link
Connect the Hardware
Register the Terminal
Connect to the Internet
Internet
7109505778 REV1.0.1
If the PON LED is solid on, please skip to Connect to the Internet.
1
Connect your computer to the Terminal via an Ethernet cable.
PON RESET LAN
2
Configure TCP/IP Properties manually on your computer.
If the Terminal's LAN IP address is 192.168.1.1, please type
in IP address 192.168.1.x (x is from 2 to 253), subnet mask
255.255.255.0, and default gateway 192.168.1.1.
3
Register the Terminal via a web browser.
A
Launch a web browser and type in http://192.168.1.1 in the
address bar. Create a password and get started.
Establish your internet connection according to your ISP's instructions.
Note: If you need assistance, contact your ISP.
Terminal
PON RESET LAN
2
Ethernet Cable
POWER
http://192.168.1.1
Power adapter
POWER
1
3
Low
B Go to Basic > Internet or Advanced > Network > GPON
setting. Enter the GPON Password and/or GPON SN
provided by your ISP (Internet Service Provider) to register
the Terminal and click Save.
Basic
Internet Connection Setup
Registration Status: Initial (01)
SN Type: ASCII+HEX
GPON SN: 54504C47B7047410
Password Type: ASCII
GPON Password:
Advanced
GPON Registration
ASCII+HEX
GPON SN: 54504C47B7047410
Password Type:
GPON Password:
OLT Mode: Normal Mode
Enjoy!
Verify that the hardware connection
is correct by checking these LEDs.
Power: On
PON: On or Flashing
LOS: Off
New Password
Middle High
Confirm Password
Save
HEX
HEX
Save
ASCII+HEX HEX
ASCII HEX
Save