Maintenance; Replacing The Filter - Hunter 30890 Owner's Manual

About every 6 months you should check your filter to see if it
needs to be replaced. Heavy build-up on the filter can cause the
energized field on the filter to not operate properly.
1. Turn the air sanitizer off and unplug it from the wall outlet.
Warning: Wait 10 seconds before opening the panel.
2. Push down on the Hunter logo to release the door. Figure 6.
3. Gently pull the door away from the unit and lift away. Figure
7.
4. Remove the HEPA Filter from the unit.
5. Clean the outside of the unit and the door with a soft, damp
cloth.
NOTE: Ensure the door is completely dry before reinstalling it
on the unit. Failure to do so could cause damage to the filters
or motor.
6. Check the filter for particle build-up.
7. If the filter needs to be replaced, remove the new filter from
it's packaging and insert it into the unit. Place the filter back
in the unit so "This side faces you" is visible. Ensure the filter
is seated fully into the unit.
NOTE: If the filter is not fully engaged in the unit, the air
sanitizer will not run.
8. Set the tabs on the bottom of the door into the notches in the
base of the unit and rock the door up until the top of the door
makes contact with the magnet. Figure 8.
9. Push the Hunter logo in until the door "clicks" into place.
10. Plug the air sanitizer back into the wall outlet and resume
use.
11. Touch the sensor pad for 3 seconds to reset the filter counter.
Note: If the filter is not seated properly inside the unit, the air
sanitizer will not operate.
6

Maintenance

Replacing the Filter

44068-01 • 05/16/2011
3
Figure 6
Figure 7
Tab
Notch
Figure 8