Installation Guide Cuba - Smart Showering Dimensions Processor CUBA-SIN-PRO 35,5 35,5 Touchpad CUBA-INT-BL (In Mm) 86,4 12,9...
Page 10
Installation Guide Cuba - Smart Showering Processor CUBA-SIN-PRO General Pressure Technology Patent pending Maximum dynamic 6 bar (0.6Mpa) Maximum load ≤15 W. (Stand-by ≤1W) Minimum dynamic 1,5 bar (0.15Mpa) Rated Impulse voltage 12 V DC Recommended dynamic 3 bar (0.3Mpa) Ingress Protection Rating IP53 Maximum differential supply...
Page 11
The Processor must be installed in an accessible location for servicing and maintenance. Provide an access panel to allow future maintenance of the Processor. No warranty claim can be considered or liability accepted by TED Connect if lack of accessibility has prevented maintenance. to be dismounted. Caution...
Page 12
Installation Guide Cuba - Smart Showering Connection Schematic Components List Prescribed Accessories Indications Sugested Accessories Factory Settings General Flow rate • Temperature • • • • • • • • • • • •...
Page 14
Installation Guide Cuba - Smart Showering Installation guidelines TUBE FOR CABLE SIDE VIEW WALL SECTION...
Page 15
User Guide Cuba Connect User Guide User Guide Cuba Connect Cuba Connect Installation & Maintenance Processor_CUBA-SIN-PRO • Avoid installing the system into enclosed locations with e • • Activate, using the touchpad, the Automatic internal clean internal impurities. (refer to the ”Touchpad user guide”).
Page 16
environmental conditions. ogram once a month to remove d (no changes in the installation or the ed to be performed at least once a year. ility if any warning / error is displayed peration. rmic acid, chlorine pale lye not mix cleaning agents. ct, such as unsuitable cleaning powders,...
Page 17
User Guide Cuba Connect Functions Summary Functions In On Mode MORE FLOW RATE Simple Push MORE TEMPERATURE (HOT) CONTINUED FLOW Simple Push INCREASE Continuous Push CONTINUED TEMPERATURE INCREASE Continuous Push LESS TEMPERATURE (COLD) Simple Push PAUSE CONTINUED TEMPERATURE Simple push...
Page 18
User Guide Cuba Connect Alarm Description & Troubleshooting REF. TYPE OF ALARM DESCRIPTION RECOMMENDED ACTION Device on standby mode detects cold water Run the automatic clean-up program. AL 1 Cold water leakage leakage. This means that the cold water valve lf the problem persists replace the device.
Page 19
• and contact time. • User Guide Cuba Connect • • After cleaning, rinse thoroughly with clean water to remove • The use of steam cleaners is not permitted. The high temp • Installation & Maintenance Indoor use only. Processor_CUBA-SIN-PRO •...
Page 20
e any cleaner residue. peratures can damage the products. oams can cause damage, so rinse with water after use.
Need help?
Do you have a question about the Cuba Connect and is the answer not in the manual?
Questions and answers