Table of Contents
Advertisement
REMOTE
CONTROL
OPERATING
INSTRUCTIONS
1)
Power
On and Off - Press the POWER
(1/O) button once to manually
turn the unit on. Press the Power
button once more to turn the unit off. When you press the POWER
button the upper right square on the
remote control LCD Display will light up. When in Air Conditioner,
Heating, and Auto mode, the selected
temperature
will appear on the remote control display. When the unit is in Fan mode and Dehumidifier
mode you will see the "- -" icon instead of the set temperature.
This shows that temperature
selection is not
available when the unit is in Fan or Dehumidifier
mode.
2)
Mode Selection
- Press the MODE
Button repeatedly
to cycle between the different
modes: Auto, Air
Conditioner,
Dehumidifier,
Fan only, and Heater mode. The upper left square on the Remote control dis-
play will light up showing which mode is selected. In Air Conditioner
mode the display will show
"COOLING",
in Heating mode the display will show "HEAT",
in Dehumidifier
mode the display will
show "DRY", in Fan mode the display will show "FAN", and in Auto mode the display will show
"AUTO".
3)
Fan Speed
- Press the FAN speed button to cycle through low, medium,
and high fan speeds. The dis-
play on the remote control will show LOW, MED, & HIGH under the "SPEED"
label on the remote con-
trol LCD display. There is an additional auto speed setting that is enabled in only heating and cooling
modes. This speed is next setting after low when pressing the FAN speed button on the remote control.
The speeds will cycle through in this order: High, Medium,
Low, Auto. Each change in speed will be as-
sociated with a "beep" sound from the unit. The remote control will not display "AUTO" under the speed
label. Once Auto fan speed is selected the unit will beep and there will not be a fan speed displayed
on the
remote control.
4)
Temperature
Settinq - When the unit is in Air Conditioner
or Heating mode you can select your desired
temperature.
Press the • or • to select your desired temperature
setting. The temperature
on the LCD dis-
play on the remote control will increase or decrease accordingly.
Pressing the • and • buttons simultane-
ously will change the temperature
select between °F and °C.
5)
SWING - To turn on the exclusive WAVEFLO(R) oscillation,
press the SWING button on the remote
control. Once you press SWING,
the louvers on the unit will oscillate up and down and back and forth.
The bottom left square of the remote control display will show the "_--V'
icon when WAVEFLO(R)
oscillation
(SW1NG) is selected.
6)
TIMER - To program the timer, first press the T-ON button. Once T-ON is pressed the auto-on timer will
blink in the bottom right rectangle of the remote control display. Press the MIN and HOUR buttons to
change the clock to the desired time for the unit to automatically
turn on. The minutes will increase by 10
with each press of the MIN button and the hours will increase by 1 with each press of the HOUR button.
Press the T-OFF
button and the remote control display will flash the desired auto-off timer. Press the MIN
and HOUR buttons to change the clock to the desired time for the unit to automatically
turn off. The timer
is set when the auto-off time stops flashing and the words "ON" and "OFF" are displayed
next to the time.
7) CLOCK - To set the clock on the remote control, hold down either the MIN or HOUR button until the
displayed time flashes on the remote control display. Change the minutes by pressing the MIN button and
change the hours by pressing the HOUR button.
12
Hide quick links:
Advertisement
Table of Contents
