Download Print this page

Grote STAR Safety Technologies CYCLONE SPBRK-42 Quick Start Manual

Speaker mounting kit, single or dual d-44 bracket fits 2020-2022 ford f-150

Advertisement

Quick Links

CYCLONE
SPEAKER MOUNTING KIT
SPBRK-42
SINGLE OR DUAL D-44 BRACKET
(FITS 2020-2022 FORD F-150)
Please Note: These instructions are provided as a general guideline only.
Specific mounting, wiring, and/or weather-sealing may be necessary and are
the sole responsibility of the installer.
responsibility for the integrity of the installation for this or any of its products.
WARNING: ALWAYS WEAR HEARING PROTECTION PER OSHA 1910.95
455 Rochester Street
585-226-9500
(F) 888-478-2797
www.StarSafetyTechnologies.com
The manufacturer assumes no
Avon, NY 14414
PLIT427-42 REV. A
2/16/24
Installation
This bracket is designed to install directly to the existing bolts and should require no drilling
or additional hardware.
IMPORTANT!
Speaker must be mounted with
drain hole/wiring exit facing down.
Failure to do so will void warranty!
1. Attach the speakers to the bracket as pictured below (dual-speaker setup shown).
Use these holes for single
speaker mounting.
2. Access the front bumper extrusion by removing the front fascia/grill/bumper cover
assembly per manufacturer instructions.
-1-

Advertisement

loading
Need help?

Need help?

Do you have a question about the STAR Safety Technologies CYCLONE SPBRK-42 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Grote STAR Safety Technologies CYCLONE SPBRK-42

  • Page 1 CYCLONE Installation SPEAKER MOUNTING KIT This bracket is designed to install directly to the existing bolts and should require no drilling or additional hardware. SPBRK-42 IMPORTANT! SINGLE OR DUAL D-44 BRACKET Speaker must be mounted with (FITS 2020-2022 FORD F-150) drain hole/wiring exit facing down.
  • Page 2 3. Remove the box-shaped speaker shroud from the vehicle. WARNING: ALWAYS WEAR HEARING PROTECTION PER OSHA 1910.95 !!! WARNING !!! 4. Install speaker and bracket Devices should be mounted only in locations listed in SAE standard J1849. assembly to bumper system Assure clearances before drilling in vehicle.