Summary of Contents for ToolMaster ATS-520A
- Page 1 Industrial Series ° ARTICULATED ATS-520A AiR BELT SANDER ARTICULATED ARM INSTRUCTION MANUAL Code: A068 www.machineryhouse.com.au www.machineryhouse.co.nz www.machineryhouse.com.au www.machineryhouse.co.nz...
- Page 2 4. Do not use this tool for other than its intended cause a hazardous situation. use. If used for other purposes, Toolmaster disclaims any real or implied warranty and 16. Check air hoses for wear, and keep them away holds itself harmless from any injury that may from heat and sharp edges.
-
Page 3: Technical Specifications
Safety Specific For Air Belt Sander 1. When the operator is not familiar with the 5. Inspect abrasive belt before operating. Do not proper and safe operation of a air belt sander, use a damaged belt. do not use the tool until proper training and 6. -
Page 4: Air Supply
Setup Any missing parts or damage should be reported immediately to your Toolmaster distributor. Do not use a damaged tool. Read this instruction manual thoroughly for operation, maintenance and safety instructions. The diagram below is the ideal setup position. The lubricator is optional and if not used, then a few drops of Pneumatic Tool Oil need to be added to the airline connection before operation. - Page 5 Operating Instructions 1. Disconnect the air tool from the air line. 2. Adjust arms to desired angles and tighten hex socket cap screws (Figure 2), with supplied hex wrench. Always tighten the hex socket cap screws firmly after adjustment, or the head could move or rotate, causing loss of control. 3. If an automatic oiler is not used, add a few drops of Pneumatic Tool Oil to the airline connection before use.
-
Page 6: Changing The Belt
Adjusting Articulation Arm Angle Disconnect air supply from the tool to prevent accidental starting and potential injury while adjusting the Arm Angle. Articulation Using the included 3mm Hex Key, loosen the screw slightly and the outer 60mm of the arm will drop and the locking screw head will slide in the curved slot allowing up to 50° of articulation. (Fig. -
Page 7: Maintenance
Review the troubleshooting and procedures in this section if a problem develops with your Air Tool. If you are still unable to resolve the problem, then contact your local Toolmaster service centre. If additional help with a procedure is required, then contact you distributor.
Need help?
Do you have a question about the ATS-520A and is the answer not in the manual?
Questions and answers