Table of Contents
Advertisement
Quick Links
This manual should be maintained in legible condition and kept
adjacent to the heat pump or in a safe place for future use.
Developed and printed in UK
For additional information call: +44 (0)844 5611 783
Manual Effective Date: 01/01/11
HL
HeatSave
Swimming Pool
Heat Pump CE
OWNER'S MANUAL
Models HL HS10, HL HS13
HL HS17 and HL HS17-T
Manufactured
by HL ( Europe )
LTD
Part No. T3601-23
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for HL HeatSave HL HS10
- Page 1 Swimming Pool Heat Pump CE OWNER’S MANUAL Models HL HS10, HL HS13 HL HS17 and HL HS17-T This manual should be maintained in legible condition and kept adjacent to the heat pump or in a safe place for future use.
- Page 2 This Warranty will be VOID if the product is repaired or altered in any way by ANY persons or agencies other than those authorized by HL (Europe) Ltd. The heat pump warranty will be VOID if chemical levels are not safe to people.
-
Page 3: Table Of Contents
HL HeatSave Swimming Pool Heat Pump OWNER’S MANUAL CE CONTENTS Introduction.......... -
Page 4: Introduction
Introduction WARNING This pool heat pump is an electromechanical machine that incorporates a pressurized refrigerant gas in a sealed system. ONLY trained and qualified service personnel are authorized to install or service this equipment. Without proper training and knowledge of such equipment, any attempt to install or service the unit could result in serious injury or even death. -
Page 5: Electrical Connections
Situate the pool heat pump carefully to minimize installation costs while providing maximum efficiency of operation, and to allow adequate service access, as follows: • For unrestricted air intake and service access, position each side of the unit at least 1 ft. from walls, pipes and other obstructions. -
Page 6: Safety Features
Water connections from the heat pump to the main return line can be PVC pipe or flexible pipe approved for the purpose and, in either case, should be at least equal in size to the main pool/spa circulation piping. 4. In cold weather (freeze zone) areas, shutoff valves (ball or gate type) must be installed at the heat pump inlet and outlet to facilitate service and cold weather drain-down. -
Page 7: Summer Shutdown
Seasonal Start-Up or Annual Check NOTE: At the beginning of the heating season or whenever the pool water temperature is to be raised several degrees, the pool pump and heat pump may need to operate continuously for several days. During summer months, only a few hours per day may be necessary or none at all. 1. -
Page 8: Maintenance
Continuous Pump Operation It is also possible in some areas to prevent heat pump freeze damage by operating the pump continuously during freezing weather. However, this results in significantly higher pump operating cost. Further, if a sustained power failure occurs, the heat pump MUST be drained anyway, or freeze damage could result. -
Page 9: Troubleshooting
IX. Troubleshooting If your heat pump does not operate, or simply does not heat your pool water, the digital display can provide valuable clues as to what is wrong, and may even indicate precisely what the problem is. Always observe these error codes before calling a service representative. By reporting on the telephone which error codes are ON, the service rep. -
Page 10: Service Call Verification
B. UNIT IS NOT RUNNING • Is the control display panel Power ON? If not, the circuit breaker may be shut OFF or tripped. Reset the breaker by switching it OFF, then back ON. Verify that the breaker is set and operating properly before calling for service. -
Page 11: Chlorinator Connecting Diagrams
Chlorinator Connecting Diagrams 1. Pressure type with Chlorinator 2. In-ine with Chlorinator Swimming Pool ...
Need help?
Do you have a question about the HeatSave HL HS10 and is the answer not in the manual?
Questions and answers