Electrical Wiring - Haier AC28NAFBEA Operation And Installation Manual

Installation of Indoor Unit

ELECTRICAL WIRING

HOW TO CONNECT WIRING TO THE TERMINALS
A.For solid core wiring (or F-cable)
(1)Cut the wire and with a wire cutter or wire-cutting pliers,then strip the insulation to
about 15/16"(25mm) of expose the solid wire.
(2)Using a screwdriver ,remove the terminal screw(s) on the terminal board.
(3)Using pliers,bend the solid wire to form a loop suitable for the terminal screw.
B.For strand wiring
(1)Cut the wire and with a wire cutter or wire-cutting pliers,then strip the insulation to
about 3/8"(10mm) of expose the solid wire.
(2)Using a screwdriver ,remove the terminal screw(s) on the terminal board.
Fig. 14
Wire
HOW TO FIXED CONNECTION CORD AND POWER CABLE AT THE CORD
CLAMP
After passing the connection cord and power cable through the insulation tube, fasten
it with the cord clamp, as shown in Fig.15
A. Solid wire
Loop
Insulation
Screw with
special washer
Round
terminal
Terminal
board
B. Strand wire
Wire
21
Round terminal
Screw with
special washer
Round
terminal