Normal Operati_G Som_Ds - GE asd06lk Owner's Manual & Installation Instructions

Troubleshooting tips...
Possible Causes What To Do
Air conditioner The air conditioner • Make sure tile ah" conditioner ph N is pushed
doesnotstart
is unplugged,
completely
into tile outlet.
The fuse is bloval/circuit * Check file house fltse/circuit bx_aker box and replace
breaker is tripped, the flLse or reset the breakec
Power failure. * If t)o_er f_filure occm_, turn tile ;fir contfitioner Off
When po_er is restored, \_;fit 3 minutes to restart the
air conditioner to prevent triplling of tile compressor
o_erload.
The current interrupter * Press tile Reset button located on file po_er cord plug.
device is lripped. • If the Reset button will not stay eng_|ged, discontinue
use of tile ;fir conditioner and contact a qu;flified
seLvice technician.
Air conditioner does Airflow is resMcted. * Make sure there are no curtains, blinds or fnmimxe
not cool as it should blocking the fi'ont of tile ;fir con(fitioner.
The temp conlrol may * On models with touc]L pads: Ill Cool mode, press the
not be set correctly.
Decrease• pad.
• On models wiflLcontrol knobs, turn file temperature
knob to a higher nurrLbex:
The air Fdter is dirty. • Clean tile tilter at least eveiw 30 dm\s.
See the Operating Instructiotis secti(;n.
The room may have been hot. • When file air conditioner is first turned on, you need
to allo\x time for tile room to cool dox_al.
Cold air is escaping. • Check for open thrnace registers and cold air returns.
• Set the air conditioner's vent to the closed position.
Cooling coils have iced up. • See "Air conditionerfreezingup"bellm.
Air conditioner
Ice blocks the air flow • On models wiflLcontrol knobs, set tile mode control
freezing up and stops the air conditioner at High Fan or High Cool\\ith the temp at I or 2.
from cooling the room. • OIl Ulodels \_ith touch pads, set tile controls at
High Fanor High Cool and set tile thermostat to
a higher mmperature.
The remote controlis The batteries are htserted • Check file position of tile batteries. They should be
not working incorrectly, inserted ill tile opposite (+) and (-) direction.
The batteries may be dead. • Replace the batteries.
Waterdripsoutside
Hot, humid weather.
• This is normal.
Water drips indoors
The air conditioner is not • For proper _Lter disposal, Lnake stu'e tile air conditioner
tilted to the outside, slants slightl} fi'om the case fl'ont to the reax:
Watercollectsin
Moisture removed from air • This is normal fbr a short period ill areas with little
basepan
and drahls into base pan. humidity; normal for a longer period ill \er\ humid areas.
"El'appears
Ftmcfion error code.
• U/lphlg
tile air c(/nditiol/er Wait 3 l//il//l[es
al/d
plug it
in the display back ill.
Timeror Sleepfeature
A power outage or htterrupdon
• Ill tile case of a power outage or interruption,
the unit
notworkingproperly occurred. Timerand Sleepfeatures \_il] reset to tile original setting.
_bu may need to set a ue\_ time if desired.
78
Normal Operating Sounds
You may hear a pinging noise caused by
water being picked uI) and thrown against the
condenser on rainy days or when tile humidiP,'
is high. This design feature helps relnove
moisture and improve eflicienc'y.
You may hear tile them/ostat click when tile
compressor c'ycles on and off.
X._ater will collect in tile base pan during
high humidit}' or on rainy days. Tile water
may overflow and drip from tile outdoor side
of the unit.
; Tile
lilll II/_:lV
rlln
even when tile COll/l)i'essor
does not.