Related Manuals for Feel Good mr.steam Basic Butler
Summary of Contents for Feel Good mr.steam Basic Butler
- Page 2 Installation, Operation & Maintenance Manual ® ® i T E M P O & i T E M P O P L U S C O N T R O L S steam ® Feel Good Inc. https://usbathstore.com...
- Page 3 When installing and using this electrical equipment, basic safety HYPERT HERMIA occurs when the precautions should always be followed, including the following: internal temperature of the body IMPORTANT SAFETY INSTRUCTIONS reaches a level several degrees above the normal body temperature of 98.6° 1.
- Page 4 steam ® Installation & Operating Instructions _________________________________________________________________ Table of Contents: R E A D M E F I R S T ! As you follow these instruc - Important Safety Instructions ......W AR N ING tions, you will notice warning and caution Before Installing ..........
- Page 5 steam ® Installation & Operating Instructions _________________________________________________________________ BE FO RE INS TA LL ING Carefully inspect the control and packaging for shipping MrSteam technical service 800-614- 7411for more information on the Remote Temperature damage. In the event of shipping damage, please contact Probe.
- Page 6 steam ® Installation & Operating Instructions _________________________________________________________________ Dimensional Information for the R ound and Square iTempo and i Tempo Plus ® ® 1” ” ” 2 ” 5” ” Box Contents: 5” ” ” 12” long pigtail Drawings for Illustrative Purposes Only.
- Page 7 steam ® Installation & Operating Instructions _________________________________________________________________ Installation Instructions for Round & Square iTempo and i Tempo Plus ® ® If the desired location for the control is outside IMP O RTA N T NO TE : the steam room a Remote Temperature Probe (MSTS) must be installed inside the steam room.
- Page 8 steam ® Installation & Operating Instructions _________________________________________________________________ STEP 2 Diagram 1 Make a 2- 5 ⁄8” wide by 3- 7 ⁄8” high cutout in the desired control location. Do not oversize or under size the cutout. STEP 3 Diagram 2 Route the control cable (provided with the DIA G RAM 2 control) from the wall cutout to the steam...
- Page 9 steam ® Installation & Operating Instructions _________________________________________________________________ STEP 5 Diagram 4 Remove and discard peel-o paper to expose adhesive liner. DIA G RAM 5 STEP 6 Diagram 5 Run a bead of silicone (provided) as shown to the outer edge of the control faceplate, following the contour of the circle or square shape.
- Page 10 steam ® Installation & Operating Instructions _________________________________________________________________ iTempo Operating Instructions ® The iTempo Control features programmable digital temperature control, a fixed (60) minute set at a temperature range from 80˚ up to 120˚ Set the steam bathing temperature W AR N ING according to personal preference, however it is highly recommended to begin steam bathing at a low temperature setting for a very short...
- Page 11 steam ® Installation & Operating Instructions _________________________________________________________________ TIMER FEAT URE When the control is turned ON a 60 minute time duration is initiated. The control will turn o after 60 minutes unless the control is turned o manually. M EM O RY FEAT URE If the control is turned o manually before 60 minutes then the default temperature of 110˚F will be used the next time the control is turned...
- Page 12 steam ® Installation & Operating Instructions _________________________________________________________________ iTempo Plus Operating Instructions ® The iTempoPlus Control features programmable temperature control, programmable time duration, clock, AromaSteam, ChromaSteam ® mr.steam two personal settings. Set the steam bathing temperature W AR N ING temp time according to personal preference, however it is highly recommended to begin steam bathing at a low...
- Page 13 steam ® Installation & Operating Instructions _________________________________________________________________ SETTI NG T H E C LOCK Diagram 3 When the display is not flashing: Press and hold the mr.steam TIME key until the display starts flashing. temp DIA G RAM 3 Press the TIME key to save changes. aroma SETTI NG T H E STEAM B AT H D URATI ON Diagram 4...
- Page 14 steam ® Installation & Operating Instructions _________________________________________________________________ SETTI NG T H E TEMPERAT URE Diagram 6: Press TEMP key to set the desired temperature or display the temperature setting. mr.steam Diagram 7: The control is preset and will display a tempera ture setting of 110˚F (default setting).
- Page 15 steam ® Installation & Operating Instructions _________________________________________________________________ C H A NG ING T H E TEMPERAT URE UN IT S aroma key for 10 seconds. The temperature units will be mr.steam displayed as Fahrenheit (TuF) or Celsius (TuC). Use temp time and exit.
- Page 16 steam ® Installation & Operating Instructions _________________________________________________________________ Display mr.steam Up Key Time Display/ Time Display/ temp time Adjust Key Adjust Key Down Key ON/OFF Key Program Key aroma chroma AromaSteam ChromaSteam Care Tips for all Controls and Steamheads 1. Use only mild soap and water on a soft cloth to clean the control and steamhead. 2.
- Page 17 ® Feel Good Inc. Products, information and specifications are subject to change without notice. For more information call Sales & Support at: Text or Call 800-614-7411 support@usbathstore.com 2019 © Sussman-Automatic Corporation MrSteam and des., AromaFlo, AutoFlush, AutoSteam, Butler Package, ChromaSteam, Clean Steam...Every Time, Club Therapy, Digital 1, Express Steam, From Bathroom to Spa, iDream Pack...
- Page 18 steam ® S T E A M H E A D ___________________________________________________________________________________________________________________________________________ I N S T A L L A T I O N I N S T R U C T I O N S 1/8" minimumclearance required when Acrylic Shield is used. See installation instructions IM PO RTA N T: See the Installation and O peration Manual Use Teflon...
- Page 19 Installation, Operation and Maintenance Manual Linear Steam Head Residential Model: 1 44080 ____________________ teri IMPORTANT: Leave this material with the homeowner. steam Feel Good Inc. ® ®...
- Page 20 Linear Steam Head ® ® Installation Section – Read Me First & Cautions Model 104480 READ ME FIRST! This signals a situation where injury or property damage may As you follow these instructions, you will notice CAUTION occur if you do not follow instructions. and IMPORTANT NOTE symbols.
- Page 21 Linear Steam Head ® ® Installation Section – Read Me First & Cautions Model 104480 • Steambath controls feature an integral temperature • See the Installation and Operation Manual provided with sensor. Locate the Steam Head in a location where steam the steam generator for additional important installation emissions will not come in direct contact with the control and operation information.
- Page 22 Linear Steam Head ® ® Installation Section Model 104480 BOX CONTENTS: • Linear Steam Head • AromaTray • Faceplate • Silicone Sealant • Diverter • Installation Instructions Figure 1 3/4” Steam Outlet Connection 1/16” 16 " Slotted Mounting Slotted Mounting Holes Holes Adjustment Screws 4 "...
- Page 23 Linear Steam Head ® ® Installation Section Model 104480 INSTALLATION STEPS Copper STEP 2. Con rm proper stud spacing: The studs must have Tubing or Brass Pipe a minimum spacing of 14-1/16” and a maximum spacing (Not Provided) 19". If the stud spacing is outside the required range then Threaded Adaptor or shim or otherwise reposition the studs as required.
- Page 24 Linear Steam Head ® ® Installation Section – Model 104480 Installing the Linear Steam Head Steps Faceplate STUD STUD STUD STUD TION INSTALLER: Because the steam head, faceplate and direct Cement Board Cement Board Cement Board Cement Board steam emission are very hot, locate the steam head and faceplate where Thin Set Thin Set...
- Page 25 Linear Steam Head ® ® Installation Section Model 104480 STEAM EMISSION ZONES W AND W/O THE DIVERTER • Plumbing must be installed by a quali ed and licensed STEP 6. Run the steam generator for a few steam cycles plumber. Plumb with rigid copper tubing or brass pipe to observe and verify that the steam head, steam head from the generator to the steam head.
- Page 26 Linear Steam Head ® ® Installation Section – Model 104480 Installing the Linear Steam Head Steps Diverter CAUTION Because direct steam emission is very hot, Diverter will become hot during steam session, and will remain hot for a period of Tile Tile time after steam session.
- Page 27 Linear Steam Head ® ® Installation Section – Model 104480 Installing the Linear Steam Head Steps AromaTray ! CAUTION: The AromaTray will become hot during a steam bath session, and will remain hot for a period of time after the steam bath session. Never touch the AromaTray during a steam bath session or for a period of time after the steam bath session.
- Page 28 Linear Steam Head ® ® Installr Section Model 104480 P104481 - Linear Steam Head, SteamHead only 104483 - LSH Faceplate 104484 - Diverter for Linear SteamHead 104482 - AromaTray for Linear SteamHead LSH Faceplate Brush Bronze 104483BB LSH FaceplateBrush Nickel 104483BN LSH Faceplate Matte Black 104483MB...
- Page 29 Linear Steam Head ® ® Model 104480 IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS FLAMMABLE LIQUID AND VAPOR • Keep the AromaSteam and fragrance away from • Contains denatured ethyl alcohol. heat, sparks, electrical outlets, open ames such as •...
- Page 30 2020 © Sussman-Automatic Corporation I MrSteam and des., A Lifetime of Pleasure, AirTempo, AromaFlo, AudioWizard, AutoFlush, AutoSteam, Butler Pa ckage, ChromaSteam, Clean Steam...Every Time, Club Therapy, CT Day Spa, Digital 1, Express Steam, Feel Good Inc., From Bathroom to Spa, HomeWizard, iButler, iGenie, iSpa Package, iSteam, iTempo, i Tempo/Plus, Linear Steamhead, Making Wellness a Way of Life, Music Therapy, My Steam, SmartSizing, Spa Package, Steam Genie, Steam on Demand, Steam in a Box, Steam@Home, SteamStart, SteamTherapy, Sussman, Tala, Tala Bath &...
- Page 31 mr . steam ® O ptional AutoFlush System ® ____________________________________________________________________________________________________________________________________________ I N S T A L L A T I O N I N S T R U C T I O N S B O X C O N TE N TS: •...
- Page 32 A utoFlush Shown Fully A ssembled IN STA LLATIO N IN STRUCTIO N S ® 1. Plumbing to be performed by a qualified plumber and shall be in accordance with applicable N ational and Local codes. Unit drains by gravity. A drain line that is lower than the AutoFlush assembly must be available.
- Page 33 A utoFlush Shown Fully A ssembled IN STA LLATIO N IN STRUCTIO N S ® 1. Plumbing to be performed by a qualified plumber and shall be in accordance with applicable national and local codes. Unit drains by gravity. A drain line that is lower than the AutoFlush assembly must be available.
- Page 34 steam ® Technical Specifications C ondensation Pan 103867 & 104402 Mr.Steam strongly recommends the use of a condensation pan in the unlikely event of a plumbing leak. Locate the condensation pan on a solid level surface and place the steam generator inside the condensation pan. Insure the steam generator is level.
Need help?
Do you have a question about the mr.steam Basic Butler and is the answer not in the manual?
Questions and answers