EN
B2
Powerbank
User Manual
cubearray.com
Instructions
Thank you for using our products.
Please read the instructions carefully
before using the product. Follow the
instructions and use it properly.
Charging B2 (Figure 1/ Figure 2)
1. Use original USB data cable and connect micro USB to
micro USB port on B2.
2. Connect USB cable to USB port on DC5V USB charger
or computer. If LED signal flickers, it means B2 is being
charged.
3. Four LED power indicators lights on, indicates that B2
is fully charged.
Please pull out power supply after
recharging fully.
Charging digital product with B2 (Figure 3)
1. Check if the charging voltage of the digital product is
compatible with the DC5V output voltage of B2.
2. Use the digital product's original cable, and connect
one end to the digital product, the other end to B2.
Then the digital product will be charged automatically.
1. When disconnecting the cable, LED signal will go out
in 10 seconds and the battery will enter sleep mode.
2. When disconnecting the cable , the 1st LED signal will
flicker if the power is less than 5% to prompt users that
the battery itself needs to be charged.
Instructions figures
z
Residual capacity indicator
LED Signal
Battery
Percentage
1st signal lights up
0~25%
1st, 2nd signals light up
25~50%
1st, 2nd, 3rd signals light up
50~75%
1st, 2nd, 3rd and 4th signals light
75~100%
up
Accessories
USB cable
User 's manual
Need help?
Do you have a question about the B2 and is the answer not in the manual?
Questions and answers