Summary of Contents for AVteq Thin 2-Bay Credenza
- Page 1 Install Guide | Thin Credenzas Thin 2-Bay Credenza Thin 3-Bay Credenza CRED2LTHIN-S CRED3LTHIN-S CRED2VTHIN-S CRED3VTHIN-S CRED2LTHIN-D CRED3LTHIN-D CRED2VTHIN-D CRED3VTHIN-D CRED3LTHIN-DX CRED3VTHIN-DX...
- Page 2 DISCLAIMER Avteq, Inc. follows the furniture industry standard of the 3’ rule with wood gain HPL surfaces. This calls for any inspection of the finish to be done from 3’ away on any wood grain HPL surface for any imperfections.
- Page 3 STEP 1 Secure uprights and wall plates to credenza • Install the [x2] uprights (B) to the back of the credenza (A) using [x8] 5/16”x1 1/4” screws (E) and [x8] 5/16 washers (F). Align holes of the uprights with the credenza’s center holes and screw from the base of the upright and middle section of the uprights.
- Page 4 Attach display uprights NOTE: If you purchased an Avteq camera mount, please refer to the assembly guide for the mount. If you are using a camera mount that attaches to the back of the display, make sure you install first before securing the display to the credenza.
Need help?
Do you have a question about the Thin 2-Bay Credenza and is the answer not in the manual?
Questions and answers