Do you have a question about the 5315-01 and is the answer not in the manual?
Questions and answers
Subscribe to Our Youtube Channel
Summary of Contents for HSE 5315-01
Page 1
INSTRUCTION MANUAL 10A MPPT* Solar Charger & Load Control Model 5315-01 60-5315-01(G) 1/5/16 *Maximum Power Point Tracking High Sierra Electronics, Inc 155 Spring Hill Dr., Suite 106 Grass Valley, CA 800-275-2080 www.highsierraelectronics.com...
Remove the contents of the package carefully and compare the contents with the enclosed packing list. Should any items be missing, notify HSE Customer Service at 800-275-2080 M-F, 7 am – 5 pm PST. Please have your packing list available when you call.
5315-01 10A MPPT Solar Charger & Load Control Instruction Manual 2.0 SPECIFICATIONS Solar Panel Sizing ........up to 150 Watt Maximum Charge Current ...... 0 to 10 A, Default = 10 A Maximum Charge Voltage ...... 0 to 15 V, Default = 14.1 V Float Voltage ...........
NOTE: Always double check for correct polarity of Batteries and Solar Panels. Do not rely on color codes alone. Applying incorrect polarity may damage the unit and will void the Warranty. Mount the High Sierra Electronics Model 5315-01 on a flat vertical surface with the case openings at the top and bottom.
5315-01 10A MPPT Solar Charger & Load Control Instruction Manual 4.0 SETTINGS 4.1 LED INDICATIONS Color Function Detail Green Flashing=Unit is on & Flashing is the normal state for this LED. microprocessor is running. Green On=Bulk charge mode The daily charge cycle will begin with slow flash as...
HSE>1025 780 25.24 0.12 17.22 2.06 0.03 13.16 Float Auto Off Night 17.03 This display will include 15 lines of data then re-print the header, for human readability. Lines of machine- readable data are preceded by the prompt HSE>. The seconds column is a 16-bit value and will roll-over after 65535 seconds.
HSE> R(E)triggerable operation= True HSE> (ESC) to exit. HSE>sec pwm temp_C sol_A sol_V sol_W bat_A bat_V charger system load mode oc_V HSE>900 780 25.24 -0.03 17.25 -0.51 0.03 13.14 Float Auto Off Night 17.01 After hitting escape again, or no input from user, the display will revert to streaming data.
Page 9
5315-01 10A MPPT Solar Charger & Load Control Instruction Manual This function provides for PWM night Press D. T enables and F disables dimming (D)imming dimming of the load when the and regenerates the Setup screen. Continue system detects low levels of light with your next change or press ESC to return (approximately 5 foot candles).
Page 10
5315-01 10A MPPT Solar Charger & Load Control Instruction Manual batteries. Nominal values for other battery types are listed below. Range is 0.00V to 15.00V. This parameter sets the battery Press C. Enter four digits representing the bat_volts_dis(C)on voltage at which the load is...
5315-01 10A MPPT Solar Charger & Load Control Instruction Manual 4.5 BATTERY VOLTAGE SETTINGS Refer to battery manufacturer’s specifications for exact settings. For 25° Sealed Flooded Max Charge V 14.0V 14.3V 14.4V Float V 13.7V 13.7V 13.7V Low V Disconnect 11.2V...
Maximum charge voltage, charge current, load current, low voltage shutdown, flashing and dimming can all be set from the simple user interface. The prompt “HSE>” precedes data values to allow parsing for remote data collection. 6.0 MAINTENANCE ...
5315-01 10A MPPT Solar Charger & Load Control Instruction Manual 7.0 TROUBLESHOOTING 1. Troubleshooting should be done by qualified service personnel. 2. Batteries store energy and can be dangerous if shorted. 3. Be careful when working with energized circuitry. 4. The charger does not house fuses or circuit breakers and there are no user replaceable parts inside.
155 Spring Hill Drive, Suite 106 Grass Valley, CA USA 95945 9.0 WARRANTY Refer to HSE Warranty Statement on our website or call to obtain more information. www.highsierraelectronics.com/customer-service/warranty or (800) 275-2080. 10.0 PARTS, SPARES AND ACCESSORIES Model 5315-01 ........Solar Charger and Load Control (10 Amp); Includes: Maximum Power...
Need help?
Do you have a question about the 5315-01 and is the answer not in the manual?
Questions and answers