If Ac Is Blocked By Storm; Removing Ac From Window - Frigidaire FAC102P1A - 10,000 BTU Air-Conditioner Installation Instructions Manual

Place the frame lock between the frame
4
extensions and the window sill as shown
(Fig. 8). Drive 3/4" (19 mm) locking
screws through the frame lock and into the sill
(FIG. 9). NOTE: To prevent window sill from
splitting, drill 1/8" (3 mm) pilot holes before
driving screws.
FIG. 8
Drive 1/2" (13 mm) locking screws
5
through frame holes into window sash
(FIG. 10/11).
FIG. 10
To secure lower sash in place, attach right
6
angle sash lock with 3/4" (19 mm) screw
as shown (FIG. 12).
FIG. 12
FIG. 9
FIG. 11
Cut foam seal and insert in the space
7
between the upper and lower sashes
(FIG. 13).
FIG. 13

If AC is Blocked by Storm

Window
Add wood as shown in FIG. 14, or remove storm
window before air conditioner is installed.
FIG. 14
STORM WINDOW
FRAME
OR OTHER
OBSTRUCTION
If Storm Window Frame must remain, be sure the
drain holes or slots are not caulked or painted
shut.Accumulated Rain Water or Condensation
must be allowed to drain out.
Removing AC From
Window
Turn AC off, and disconnect power cord.
*
Remove sash seal from between windows,
*
and unscrew sash lock.
Remove screws installed through frame and
*
frame lock.
Close (slide) side panels into frame.
*
Keeping a firm grip on air conditioner, raise
*
sash and carefully "rock" air conditioner
backward to drain any condensate water in
base of unit. Be careful not to spill any
remaining water while lifting unit from
window. Store parts WITH air conditioner.
3
SASH
BOARD
THICKNESS
AS REQUIRED,
1 1/2" MIN
FOR PROPER
(38 mm)
PITCH TO
REAR, ALONG
ENTIRE SILL.
FASTEN WITH
NAILS OR
SCREWS.