Advertisement
Quick Links
APPLICATION
For stadium and large arena lighting. Can also be used for shipyards, airports, docks and other high pole
installation applications. Can also be used for long-distance small-angle projection and large architectural
outline lighting.
CAUTION
1. The product should be installed, inspected and maintained by a qualified electrician in accordance
with local national electrical safety regulations.
2. Turn off power before checking, installing or removal.
3. Ensure that the voltage used is the voltage within the product identification range.
4. Use wires that comply with UL (or other local standards) for wiring. The voltage AC100-277V should be
wired with not less than 14AWG and the voltage AC277-480V should be wired with not less
than 16 AWG.
5. Do not install in a hazardous environment. The ambient temperature must not exceed the rated
operating temperature of the product.
6. Do not install the product when it rains. Avoid the danger of lighting strikes and avoid accidents.
7. Please use with listed waterproof strain relief bushing when connecting the power supply cord
to outlet box.
8. Can not use the electric generator to test the LED lamp.
9. External 0-10V only passive dimmers are supported.
WIRING DIAGRAM
Notice: Please use the dimming +, dimming - (DC10V) marking leads to connect to outside dimmer.
Class 1 wiring only.
Please assure a cumulative leakage current of less than 3.5mA on the control circuit.
The AUX control wire with shrinkable tubing shall not be damaged (no connection)
Installation Guide
WWW.ENVISIONLEDLIGHTING.COM
DIM +
DIM -
Black/Brown: ACL
Green/Yellow
White/Blue: ACN
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Envision LED-SPL-3P
Summary of Contents for Envision LED-SPL-3P
- Page 1 WWW.ENVISIONLEDLIGHTING.COM Installation Guide APPLICATION For stadium and large arena lighting. Can also be used for shipyards, airports, docks and other high pole installation applications. Can also be used for long-distance small-angle projection and large architectural outline lighting. CAUTION 1. The product should be installed, inspected and maintained by a qualified electrician in accordance with local national electrical safety regulations.
-
Page 2: Pole Mounting
Power Box Installation: Use a tool to loosen the four M6 nuts that fix the power supply box, slide the power supply box along the guide rail and move it to a suitable position, tighten the four M6 nuts to fix the power supply box (Fig. 1) Figure 1 Installation of LED Lamps 1: POLE MOUNTING... - Page 3 5. Adjust the projection point to the light beam angle of your choice. 6. Complete the projection angle adjustment and lock the adjustment screws 7. According to the previous wiring diagram and select one desired method of wiring. Figure 6 Installation of LED Lamps 2: POLE MOUNTING 1.
- Page 4 Adjustable Fitter Mounting 1. Remove the bracket mounting screws on the fixture and run the wires through the bracket. (Fig. 10) 2. Install the bracket on the fixture (Fig. 11) Figure 10 Figure 11 3. Use an open-end wrench and hex wrench to loosen the adjusting screw for adjusting the angle (Fig 12) Notice: Adjustable angle is 0-90˚...
- Page 5 Photocell Placement When the photocell function is required, photocell should be installed on the back of the lamp. When it is not required shorting cap should be installed on the back of lamp. (Fig. 14) Figure 14 Figure 15 Wattage Selection The light fixture with watt adjustable function, tear off the plug, switch it to the tap position you need (Fig.
Need help?
Do you have a question about the LED-SPL-3P and is the answer not in the manual?
Questions and answers