Subscribe to Our Youtube Channel
Related Manuals for Nexigo DLP-L01
Summary of Contents for Nexigo DLP-L01
- Page 1 DLP-Link 3D Glasses User Manual DLP-L01 User Manual Register to get EXTRA @LetsNexiGo ONE year warranty Online Support...
-
Page 2: Contact Information
From all of us here at NexiGo, we want to thank you for your trust in us. We look forward to serving you again in the near future. -
Page 3: Safety Warning
SAFETY WARNING NexiGo recommends that all viewers take regular breaks to avoid eye strain. Some people may experience physical discomfort while using this product. This discomfort may take the form of eye strain, nausea, or fatigue. If you experience any of these symptoms, please take a break. -
Page 4: Maintenance
MAINTENANCE To clean the 3D Glasses, wipe them gently with a soft lint-free cloth. Never clean them using strong solvents (e.g. thinners, alcohols, or benzine). Ensure that the 3D Glasses don’t come in contact with fire or water. Only charge the Glasses using the supplied USB cable. Do not use or store the 3D Glasses in high temperatures or direct sunlight. -
Page 5: Product Introduction
PRODUCT INTRODUCTION Power Button LED Indicator Micro USB Charging Port Signal Receiver Liquid Crystal Lens LIQUID CRYSTAL LENS These Glasses feature high-quality LCD lenses so you can enjoy 3D content on your projector in ultra-high resolution. SIGNAL RECEIVER The 3D Glasses work by receiving infrared signals from a 3D Sync Transmitter built into your projector. - Page 6 POWER BUTTON Power On: Press once. 3D Reversal: When the Glasses are powered on, tap once to switch the direction of the 3D image sequence between left-to-right and right-to-left. Power Off: Press and hold the power button for 3 seconds, until the LED Indicator flashes three times and turns off.
- Page 7 Charge Connection Please ensure that the 3D Glasses are fully charged before using them for the first time. Fully charge the 3D Glasses at least once every six months, even when they haven’t been used.
-
Page 8: Specification
SPECIFICATION Lens Liquid Crystal with Active Shutter Working Distance 26.2ft (8 m) Rate Input DC 5V Working Temperature 0°C–40°C Storage Temperature -10°C–75°C OPERATION GUIDE SETUP 1. Fully charge the 3D Glasses before using them for the first time. 2. Display 3D content on your projector. Refer to the operation manual for your projector to enable 3D content on your device. -
Page 9: Fcc Requirement
Recommended viewing distance 6.5ft 26.2ft FCC REQUIREMENT Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. - Page 10 WEEE CORRECT DISPOSAL OF THIS PRODUCT (WASTE ELECTRICAL & ELECTRONIC EQUIPMENT) (Applicable in countries with separate collection systems) This marking on the product, accessories or literature indicates that the product and its electronic accessories (e.g. charger, headset, USB cable) should not be disposed of with other household waste at the end of their working life.
Need help?
Do you have a question about the DLP-L01 and is the answer not in the manual?
Questions and answers