Advertisement
Quick Links
Horn Kit
RT600 or RT1200 Trencher
Model No. 25409
Model No. 25409E
Note: Determine the left and right sides of the machine from the normal operating position.
Safety
This product contains a chemical or chemicals known to the State of California to
Safety and Instructional Decals
Safety decals and instructions are easily visible to the operator and are located near any area of potential
danger. Replace any decal that is damaged or lost.
1. Horn
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
104-6957
Description
No parts required
Wiring harness
Horn
Mounting bracket
Thread locker
Register at www.Toro.com.
WARNING
CALIFORNIA
Qty.
–
1
1
1
1
Form No. 3394-706 Rev B
Installation Instructions
Use
Prepare the machine.
Route the wire harness.
Mount the horn (RT600 units only).
Original Instructions (EN)
All Rights Reserved *3394-706* B
Printed in the USA
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Toro 25409
- Page 1 Form No. 3394-706 Rev B Horn Kit RT600 or RT1200 Trencher Model No. 25409 Model No. 25409E Installation Instructions Note: Determine the left and right sides of the machine from the normal operating position. Safety WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
-
Page 2: Preparing The Machine
Procedure Description Qty. Horn Mounting bracket Mount the horn (RT1200 units only). Thread locker Horn switch Decal Install the horn switch. Cable ties – No parts required Test the horn function. Preparing the Machine Routing the Wire Harness No Parts Required Parts needed for this procedure: Wiring harness Procedure... - Page 3 Figure 4 RT1200 Figure 2 RT1200 1. Nut 3. Ring terminal 2. Battery-disconnect switch 4. Engine ground 1. Insulator lug 4. Ring terminal 2. Nut 5. Positive terminal 3. Lockwasher 6. Battery-disconnect switch 5. Route the wiring harness beneath the side ledge toward the nose of the machine.
- Page 4 Mounting the Horn (RT600 Units Only) Parts needed for this procedure: Horn Mounting bracket Thread locker Procedure Figure 6 1. Remove the mounting strap and nut from the horn. 1. Mounting bracket 3. Nut Note: Discard the mounting strap. 2. Bolt 2.
- Page 5 Mounting the Horn (RT1200 Units Only) Parts needed for this procedure: Horn Mounting bracket Thread locker Procedure 1. Remove the mounting strap and nut from the horn. Figure 9 Discard the mounting strap. 1. Bolt 3. Existing bracket 2. Apply the thread locker to the horn stud. 2.
- Page 6 Installing the Horn Switch Parts needed for this procedure: Horn switch Decal Cable ties Procedure 1. On the left side of the steering column, remove the plug shown in Figure Figure 12 1. Bolt 2. Kick panel 3. Connect the wiring harness to the horn switch (Figure 13).
- Page 7 Testing the Horn Function No Parts Required Procedure Confirm that the horn sounds when you press the horn button and stops when you release it. Note: If the horn does not sound, ensure that the wiring harness connectors are secure. Figure 14 1.
Need help?
Do you have a question about the 25409 and is the answer not in the manual?
Questions and answers