Rosetta BELVEDERE Quick Tips

Thank you for choosing Rosetta hardscape products. The following
are some helpful tips to make your first installation go smoothly. For
more in-depth technical information, see our Rosetta Technical Guide
(available at rosettahardscapes.com) or contact Rosetta Tech Support.
Your safety is important to us. Please follow OSHA guidelines, and
utilize safety-toe boots, hardhats, gloves and eye, ear & respiratory
protection whenever appropriate.
PATIO TOP INSTALLATION
• Fire pits should never be installed atop a patio surface. Rather, the fire
pit should be "cut in" to the patio surface to avoid damage to the patio.
SETTING THE PROPER CIRCUMFERENCE
• Place the steel liner, lip-side down, at the point of installation. Build
the base layer around this liner to approximate proper circumference.
Adjust the circumference as necessary. Remember to flip the steel liner,
lip-side up, after completing the first row of block.
PATTERN
• Follow the attached block layout pattern to build the fire pit.
SECURING THE COPING
• Adhere the coping to the top row of block with landscape adhesive.
VENTILATION CLEARANCE
• On the finished fire pit, the steel liner should rest approximately ¼"
below the coping. This will allow for proper heat dispersal, extending the
life of your fire pit.
Rosetta Tech Support: (231) 675-4979 • www.rosettahardscapes.com
BELVEDERE FIRE PIT
QUICK INSTALL TIPS
REQU IRE D TOOL S
• LEVEL
• TAPE MEASURE
• LANDSCAPE
ADHESIVE