Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Alert-it P164 MKII
- Page 1 Instructions for Use P164 MKII Safelink Radio Repeater This document applies to; P164 MKII [Product version 1 & 2] Alert-iT and the Alert-iT logo are either registered trademarks or trademarks of iTs Designs Ltd. Copyright @ 2023 iTs Designs Ltd.
- Page 2 If you have any questions or require assistance in regards to this product or any other Alert-iT product, our experienced team are on hand to help. Please find contact details below. Don’t forget you can also join us on Facebook, Twitter and LinkedIn where you’ll find even more information and advice.
-
Page 3: Table Of Contents
INSTALLATION OF THE REPEATER................................9 Selecting a Suitable Location........................................9 Installation..............................................9 INSERTING BATTERIES AND BATTERY SERVICE LIFE..........................10 CHECKS........................................11 Monthly Checks............................................11 Quarterly Checks............................................11 ALERT-IT LIMITED WARRANTY STATEMENT............................12 TECHNICAL SPECIFICATIONS..................................14 Control Unit...............................................14 Ambient Conditions..........................................14 Product Conformity...........................................14 CLEANING......................................15 DISPOSAL OF THE DEVICE AFTER USE..............................15 DECLARATIONS OF CONFORMITY................................15... -
Page 4: Important Safety Precautions
Important Information and Limitations for Use. Read Before Use This Alert-iT product has been designed with due regard to reliability and integrity. While this system offers a highly vigilant alerting method, it is always possible that a distress condition can go undetected for a variety of reasons (including malfunction) and in life threatening situations it is advisable to use the Alert-iT system in conjunction with additional techniques. -
Page 5: Package Contents
PACKAGE CONTENTS [P164 MKII] (Fitted) [P160C] (Not Shown) (Not Shown) [P171] (Not Shown) [Inc. screws, wall plugs & sticky pads] (Not shown) www.alert-it.co.uk... -
Page 6: Guide To Symbols
Indicates that the product is in compliance with the European directive 2002/95/EC on the restriction of the use of certain hazardous substances in electrical and electronic equipment (commonly referred to as the Restriction of Hazardous Substances Directive or RoHS). www.alert-it.co.uk... -
Page 7: Introduction
● Follow all instructions provided in this document concerning the installation, use and cleaning of the device. Product Description This product is a wall mounted Radio Repeater used to extend the radio range of any of Alert-iT’s wireless radio products. -
Page 8: Control Unit Overview
The device can be left in this state for a while, but if it is to be left in storage for many months, it is recommended to remove the batteries to stop any damage to the batteries from them being discharged completely flat. www.alert-it.co.uk... -
Page 9: Installation Of The Repeater
If the new boosted range is insufficient or there is a direction in which the signal strength needs boosting then more Repeaters can be fitted without limit. The green “Power” LED will blink when running on the battery backup, it will blink faster when the battery is getting low. www.alert-it.co.uk... -
Page 10: Inserting Batteries And Battery Service Life
NOTE: Although Ni-MH batteries rarely leak, they do suffer from reduced capacity if allowed to discharge completely flat. So if the device is being placed into long term storage it is recommended to remove the batteries first. Contact your equipment provider for recommended batteries. www.alert-it.co.uk... -
Page 11: Checks
” LED will flash slowly when mains power is first turned off, then flash quickly when the batteries are very low. The “ ” light flashes each time a radio backed is boosted. If the backup battery life is insufficient, replace the batteries. Batteries = 2x www.alert-it.co.uk... -
Page 12: Alert-It Limited Warranty Statement
- treatment resulting in physical, cosmetic or surface damage or changes to the product. - failure to install or use the product for its normal purpose or in accordance with Alert-iT’s instructions on installation or use. - failure to maintain the product in accordance with Alert-iT’s instructions on proper maintenance. - Page 13 If this exclusion is not permitted or fully permitted by applicable law, Alert-iT excludes or limits its warranties only to the maximum extent permitted by applicable law. Any warranty that cannot be fully excluded will be limited (as far as permitted by applicable law) to the duration of this Guarantee.
-
Page 14: Technical Specifications
TECHNICAL SPECIFICATIONS Equipment is for continuous operation. 11.1 Control Unit Model: P164 MKII Power: 12V DC Power. Battery Backup. 2x Ni-MH AA Battery (HR6) 2400mAh. Backup Battery: Up to 48 hours. Charging Time: 12 hours. Signal Lights: Green POWER light. Red STATUS light. -
Page 15: Cleaning
The manufacturer, iTs Designs Ltd., hereby declares that this product is in compliance with the Radio Equipment Regulations (UK) 2017 and the Radio Equipment Directive (2014/53/EU). The full text of the declaration of conformity is available at the following internet address; www.alert-it.co.uk/support/ www.alert-it.co.uk... - Page 16 Alert-iT Care Alarms Fernie House (Unit 3) Coalville Business Park Jackson Street Leicester, UK LE67 3NR +44 (0) 1530 239 900 support@alert-it.co.uk www.alert-it.co.uk UH1466AA P164 MKII User Manual - English - Alert-iT v2.0...
Need help?
Do you have a question about the P164 MKII and is the answer not in the manual?
Questions and answers