Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for PowerLogic P-CUBE
- Page 1 P - C U B E Po r t a bl e powe r p ack User Manual Pure Sine Wave 500W Power Inverter & Uninterrupted Power Supply Model 48A/hr and 24A/hr © 2020 Copyright Powerlogic SA (Pty) Ltd Rev. 4 09/2020...
- Page 2 SA (Pty) Ltd. Powerlogic SA (Pty) Ltd. 10 Cane Road, PO Box 84, Ottery 7808, Cape Town, South Africa Tel: (+27) 21 704 1450 • Fax: (+27) 21 704 1424 info@powerlogic.co.za www.powerlogic.net © 2020 Copyright Powerlogic SA (Pty) Ltd Rev. 4 09/2020...
-
Page 3: Table Of Contents
2. Product Specifications 2.1 Batteries 2.2 Inverter 2.3 Power Outlets 2.4 USB Ports 3. Safety & Handling 3.1 General Safety Precautions 3.2 Handling & Cleaning 4. Tips & Troubleshooting 5. Warranty Information © 2020 Copyright Powerlogic SA (Pty) Ltd Rev. 4 09/2020... -
Page 4: General Information
6 hours of power depending on the load (Note the smaller model has 24Ahr capacity). The P-CUBE’s primary function is to provide back-up in the event of a power failure or load shedding to entertainment equipment, computers, laptops and lighting (see page 8 - 1.5 Devices that can be... -
Page 5: Product Features
Chromed handle hooks 2 x Ventilation grids 2 x 3 pin ZA sockets Standard SA Socket AC power outlet switch Chromed strap hooks CAUTION! DO NOT BLOCK VENTILATION GRIDS DURING OPERATION © 2020 Copyright Powerlogic SA (Pty) Ltd Rev. 4 09/2020... - Page 6 P - C U B E User Manual innovative power technologies SA (Pty) Ltd. Upper Wall-mounting wing Lower Wall-mounting wing Power cable compartment DC input jack 12V - 37V Cable swivel on power cable Ventilation grid © 2020 Copyright Powerlogic SA (Pty) Ltd Rev. 4 09/2020...
- Page 7 2. Carefully fit the P-CUBE onto the wing bracket Bracket mounted to surface Upper wall mounting wing Lower wall mounting wing can be used to mount the P-CUBE upside down © 2020 Copyright Powerlogic SA (Pty) Ltd Rev. 4 09/2020...
-
Page 8: Operating Instructions
AC Power Switch (Blue rocker). 1.3.5 Using the USB Ports The 2 Port USB Smart Charger is rated at 3.1A and can supply 3.1A shared between the two ports. © 2020 Copyright Powerlogic SA (Pty) Ltd Rev. 4 09/2020... -
Page 9: Charging The P-Cube
The batteries will be approximately 80% charged in 2-3 hours, and fully charged in approximately 4-6 hours. Note: The P-CUBE will continue to draw a small amount of power even when turned o . If the unit is not used for some time, it may require charging before it is next used. -
Page 10: Dc Charging
3000 cycles or approximately 8 years depending on the frequency of charge and discharge cycles. General Safety: Unplug the P-CUBE charging lead if any of the following conditions exist: The power cord or plug has become frayed or damaged. -
Page 11: Devices That Can Be Powered By The Unit
Ensure that the total wattage being drawn does not exceed 500W. 1.6 Calculating battery life based on usage The P-CUBE has 16 x 12Ah, 3.2V cells, (for the 48A/hr model) totalling 500Wh when the unit is fully charged. It is important to note that this... - Page 12 500Wh by the total wattage drawn by the devices running o the unit. Running time will vary depending on the type and amount of devices running o the unit. Examples of devices that can be powered by the P-CUBE and approximate running times: Total: 142W Approx.
-
Page 13: Product Specifications
2.5 DC Charge Port DC voltage from 12v to 37v max. Current max. charge 5A Use Barrel Connector with 2.1mm centre pin and 5.5mm barrel. (Type 5521) Internal reverse polarity protection. © 2020 Copyright Powerlogic SA (Pty) Ltd Rev. 4 09/2020... -
Page 14: Safety & Handling
. Allow it to dry thoroughly before turning it on again and do not attempt to dry the unit with an external heat source such as a hair dryer. A P-CUBE that has been damaged as a result of exposure to liquids is not serviceable. -
Page 15: Handling & Cleaning
P-CUBE or other property. 3.2. Handling and Cleaning Carrying the P-CUBE: The unit contains sensitive and relatively heavy components. When carrying the unit, pick it up carefully and make sure that the handle is securely clipped in. -
Page 16: Tips & Troubleshooting
SA (Pty) Ltd. When you’re using the P-CUBE or charging the battery, it is normal for the unit to become warm. The exterior of the P-CUBE functions as a heat sink and transfers heat from inside the unit to the cooler air outside. -
Page 17: Warranty Information
Powerlogic warrants that this product will be free from defects in materials and workmanship for a period of one (1) year following the date of purchase.
Need help?
Do you have a question about the P-CUBE and is the answer not in the manual?
Questions and answers