Gossen MetraWatt NA HIT 2X Supplement

SUPPLEMENT
3-447-215-03
1/11.23
NA HIT 2X
POWER PACK FOR METRAHIT H&E CAR, METRAHIT 27I, METRAHIT 27M
1 SAFETY INSTRUCTIONS
Read and follow these instructions carefully and completely in
order to ensure safe and proper use.
The instructions must be made available to all persons who
use the product.
Keep for future reference.
General

The device may only be used by adequately trained electricians in the
commercial sector.
 Wear suitable and appropriate personal protective equipment (PPE)
whenever working with the instrument.
Handling

Carefully and completely read and adhere to the product documenta-
tion for the associated test/measuring instrument.

Use the product only for its intended purpose in accordance with this
documentation and the documentation for the associated test/measur-
ing instrument.

Use the product in undamaged condition only.
Inspect the product before use. Pay particular attention to damage, in-
terrupted insulation or kinked cables.

If the product doesn't function correctly, discontinue use of the product
and dispose of it properly.

If the product is damaged during use, for example if it's dropped, dis-
continue use of the product and dispose of it properly.
 If there are any signs of interior damage to the product (e.g. loose parts
in the housing), permanently remove the it from operation and secure it
against inadvertent use.
 Route cables in an orderly fashion. Loose, disorderly cables result in un-
necessary danger of tripping and falling.
Operating Conditions

Do not use the product after long periods of storage under unfavorable
conditions (e.g. humidity, dust or extreme temperature).

Do not use the product after extraordinary stressing due to transport.

Do not expose the product to direct sunlight.

Only use the product within the limits specified in the technical data and
operating conditions (ambient conditions, IP protection code, measur-
ing category etc.).
2 APPLICATIONS
Please read this important information!
2.1 INTENDED USE /
USE FOR INTENDED PURPOSE
Power pack NA HIT 2x (Z218H), hereinafter referred to as product, is used
for mains operation of the instruments listed below, especially for continu-
ous measurements. Only the following instruments may be operated with
the product:

METRAHIT H&E CAR (M227T)
 METRAHit 27I (M227B)

METRAHit 27M (M227A)
Safety of the user, as well as that of the product, is only assured when it's
used for its intended purpose.
2.2 USE FOR OTHER THAN INTENDED PURPOSE
Use of the product for any purposes other than those described in this sup-
plement, or in the product documentation for the associated test/measuring
instrument, is contrary to use for intended purpose. Use for Other than In-
tended Purpose may lead to unpredictable damage!
NA HIT 2X
2.3 LIABILITY AND GUARANTEE
Liability and guarantee granted by Gossen Metrawatt GmbH complies with
the applicable contractual and mandatory legal regulations.
3 PRODUCT
3.1 SCOPE OF DELIVERY
1 NA HIT 2x (Z218H)
1 Supplement (this document)
3.2 SYMBOLS ON THE PRODUCT
Symbol
Meaning
Warning concerning a point of danger
!
(attention, observe documentation!)
Double insulation (protection category II)
European conformity marking
The product may not be disposed of with household trash. You
are required to comply with all applicable local regulations.
Further information regarding disposal can be found on our
website.
3.3 TECHNICAL DATA
Input:
Power Supply
Output:
Measuring Category
CAT IV 600 V, CAT III 1000 V
Mains plug: Euros
Measuring/test instrument: see Kapitel "Intended
Connections
Use / Use for Intended Purpose"
Operating temperatures: 0 ... +40 °C
Storage temperatures: -20 – +60 °C
Ambient
Relative humidity: max. 75%, no condensation
Conditions
allowed
Elevation: max. 2000 m
Protection, housing: IP68
per DIN EN 60529 / IEC 60529
Mechanical
Cable length: 1.5 m
Design
W × H × D: approx. 75 × 58 × 26 mm
Weight: approx. 140 g
90 V ... 253 V AC , 50/60 Hz
5 V DC , 1000 mA

1
1 | 2