9. BEFORE FIRST USE..................21 10. PROGRAMMES....................21 WI-FI - CONNECTIVITY SETUP..............26 12. DAILY USE....................... 29 13. HINTS AND TIPS....................35 14. CARE AND CLEANING..................36 15. TROUBLESHOOTING..................43 16. CONSUMPTION VALUES................47 17. QUICK GUIDE....................49 18. ENVIRONMENTAL CONCERNS..............51 My AEG Care app...
ENGLISH FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler – features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
Page 5
Children between 3 and 8 years of age and persons • with very extensive and complex disabilities shall be kept away from the appliance unless continuously supervised. Children of less than 3 years of age should be kept •...
ENGLISH The appliance must be connected to the water mains • using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre. Old hose sets must not be reused. • If the mains power supply cable is damaged, it must •...
Page 7
2.4 Use to a grounding connection in the building. • Always use a correctly installed WARNING! shockproof socket. Risk of injury, electric shock, • Make sure that the parameters on the fire, burns or damage to the rating plate are compatible with the appliance.
PODS, equipped with a system effectiveness of the stain remover. able to spread and mixing the • The AEG Steam Fragrance, thanks detergent in an optimal way, and to to the steam programmes offers the dissolve the detergent residues after perfect solution for refreshing even each cycle.
ENGLISH Level of protection against ingress of solid particles and IPX4 moisture ensured by the protective cover, except where the low voltage equipment has no protection against mois‐ ture Water supply pressure Minimum 0.5 bar (0.05 MPa) Maximum 10 bar (1.0 MPa) Cold water Water supply Maximum Load...
Page 11
5. Carefully put the appliance down on It is possible to see its rear side. water flowing from the 6. Put the front polystyrene packaging drain hose. This is due element on the floor under the to the testing with water appliance.
Page 12
If you install the appliance on a plinth adjust the level. that is not an accessory supplied by AEG, secure the appliance with the fixing plates. This spare part is available in web shop or from authorised dealer. Read carefully the instructions supplied with the accessory.
Page 13
You can extend the drain hose to maximum 400 cm. Contact the authorized service centre for the other drain hose and the extension. It is possible to connect the drain hose in different ways: 1. Make a U shape with the drain hose...
Page 14
ENGLISH 6. Position the hose directly to a built- in drain pipe in the room wall and tighten it with a clamp. 5.7 Electrical connection The end of the drain hose must always be ventilated , At the end of installation you can connect i.e.
6. CONTROL PANEL 6.1 Control panel description The options are not selectable with all washing programmes. Check the compatibility between options and washing programmes in the "Options compatibility with programmes" paragraph in the "Programmes" chapter. An option can exclude another one, in this case the appliance doesn't allow you to set the incompatible options together.
Page 16
ENGLISH 6.2 Display Door locked indicator. Washing phase indicator. It flashes during pre-wash and wash phase. Rinsing phase indicator. It flashes during rinse phase. Spinning and draining phase indicator. It flashes during spin and drain phase. Steam phase indicator. Anti-crease phase indicator. Eco programme indicator: it lights on when the selected programme and options have an eco profile.
Page 17
The digital indicator can show: • Programme duration (e. g. The time shown when the programme is set could not correspond to effective duration and change af‐ ter ProSense phase. • Maximum load. • Finish in time (e. g.
ENGLISH 7. DIAL AND BUTTONS 7.1 Marche/Arrêt 7.4 Introduction Pressing this button for a few seconds The options/functions are allows to activate or deactivate the not selectable with all appliance. Two different tunes sound washing programmes. while switching the appliance on or off. Check the compatibility between options/functions As the Stand-by function automatically...
Page 19
This option allows choosing the time The indicator blinks on the display within which a programme should during steam phase. terminate. The programme end can be This option can affect the postponed by one 1 hour every button programme duration.
Page 20
ENGLISH In this case, the temperature 95°C is The display shows only not selectable. the spin speeds available The led of the button is on and the for the set programme. display shows the set programme • Activate the Rinse Hold option . duration.
7.14 Température When the display shows the indicators , the appliance does not heat When you select a washing programme, the water. the appliance automatically proposes a default temperature. Touch this button repeatedly until the desired temperature value appears on the display.
ENGLISH 1. Switch the appliance on by pressing 3. The display will show Marche/Arrêt button. about 5 seconds. 2. Press and hold the Taches/ Prélavage and Gain de Temps buttons for some seconds. 9. BEFORE FIRST USE 3. Pour 2 litres of water into the During installation or before detergent compartment marked by first use you may observe...
Page 23
Programme Programme description Machine washable wool, hand washable wool and other fabrics with «hand washing» care symbol Laine Cotton and synthetic items lightly soiled or worn only once. 20 min. - 3 kg Cotton, synthetic and mixed items. Special steam cycle without...
Page 24
Steam programmes can be used for 10.2 Vapeur programme reducing wrinkles and odours of with AEG Steam Fragrance garments that just need to be refreshed, avoiding washing. Steam programme Available in www.aeg.com/shop .
Page 25
Hang items out for a few minutes. The fragrance dose bottles are available on AEG web The fragrance. If you use this special shop or by authorised gentle fragrance, your laundry will scent dealer.
QR code can be used in two ways: Frequency 2.412 - 2.472 GHz • Scan the QR code with the built-in for European mar‐ camera app to download the My AEG Care application from the App store on your smart device and follow the Protocol IEEE 802.11b/g/n required steps.
Page 28
The access point will be open for about 3 not have an account, create a new minutes. one following the instructions in My 5. Configure the My AEG Care app on AEG Care. your smart device and follow the 5. Follow the instructions on the App for...
Page 29
1. Touch the Départ à distance button and the indicator blinks on the display for a few seconds. Every time you switch the appliance on, the appliance takes about 10 seconds to connect to the network 2. Touch the Départ/Pause button automatically.
ENGLISH 11.6 Wi-Fi Always On It is possible to turn the appliance on by pressing the Marche/Arrêt button or The Wi-Fi Always On function is through the App. available in the App. The Wi-Fi Always On This function keeps the appliance function may affect your connected to the network even when the energy consumption.
Page 31
12.3 Filling the detergent and After a washing cycle, if additives necessary, remove any detergent residue from the detergent dispenser. Proceed as follows 1. Open the detergent dispenser. - Compartment for detergent pods (Max 2 pods). When using detergent tab‐...
Page 32
ENGLISH declared load for the set programme (only for a few seconds), the default temperature, the default spin speed and the washing phase indicators (when available). 2. To change the temperature and/or the spin speed, touch the related buttons. 3. If desired, set one or more options by touching the related buttons.
Page 33
To change or cancel this In case of in case of option: drum overload, the maximum declared load 1. Switch the appliance off by means of indicator comes on again the Marche/Arrêt button. with the indicator 2. Switch the appliance on again.
Page 34
ENGLISH When the phase ends the relevant If the ProSense phase is indicator stops flashing and is steady on. already carried out and the The next phase indicator starts flashing. water filling is already started, the new programme E.g. the rinse phase is running: starts without repeating the ProSense phase.
Page 35
(if they are 2. Touch the Départ/Pause button: active). • If you have set , the appliance In the display all washing phase drains the water and spins. indicators become steady and the time • If you have set , the appliance area shows .
ENGLISH 13. HINTS AND TIPS WARNING! Refer to Safety chapters. 13.1 The laundry load • Divide the laundry into: white, coloured, synthetics, delicates and wool. • Follow the washing instructions on the • Empty pockets and unfold the items. laundry care labels. •...
• Use only detergents and other • inadequate rinsing, treatments specially made for • a greater impact for the environment. washing machines. First, follow these 13.4 Ecological hints generic rules: – powder detergents (also tablets To save water, energy and to help...
Page 38
ENGLISH 14.4 Descaling Maintenance wash Once a month If the water hardness in your Clean door seal Every two months area is high or moderate, we recommend that you use a Clean drum Every two months water descaling product for washing machines.
Page 39
4. Add a manually small quantity of powder detergent or a specific product into the empty drum, in order to rinse out any left residues. Occasionally, at the end of a cycle the display may show the icon : this is a recommendation to perform the “drum cleaning”.
Page 40
ENGLISH 4. Wash the detergent dispenser and 7. Make sure that all detergent residue any insert under running water. is removed from the conveyor. Use only soft damp clothes. 8. Put bottom cover back to its position by aligning its holes on drawer hooks as indicated in the picture.
Page 41
• The appliance makes an unusual noise because of the blockage of the drain pump. • The display shows the alarm code CLICK WARNING! • Do not remove the filter while the appliance operates. • Do not clean the pump if the water in the appliance is hot.
Page 42
ENGLISH 11. Put the filter back into the special guides by turning it clockwise. Make sure that you tighten the filter correctly to prevent leakages. 5. When the bowl is full of water, turn the filter back and empty the container.
Page 43
1. Remove the inlet hose from the tap and clean the filter. 45° 20° 14.11 Emergency drain If the appliance cannot drain the water, carry out the same procedure, described 2.
ENGLISH 15. TROUBLESHOOTING WARNING! Refer to Safety chapters. 15.1 Alarm Codes and Possible failures The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to the tables). WARNING! Deactivate the appliance before carrying out any check. With some problems, the display shows an alarm code and the Départ/Pause button may flash continuously:...
Page 45
• Make sure that the sink spigot is not clogged. • Make sure that the drain hose has no kinks or bends. The appliance does • Make sure that the drain filter is not clogged. Clean the filter, if not drain the water.
Page 46
ENGLISH Problem Possible solution • Set the spin programme. If the drain programme is not availa‐ The spin phase does ble in the programme dial, it can be set via App’. not operate or the • Make sure that the drain filter is not clogged. Clean the filter, if washing cycle lasts necessary.
Page 47
Problem Possible solution • Make sure that the wireless signal reaches the appliance. Try to move the home router as near the appliance as possible or The App cannot fre‐ consider purchasing a wireless range extender. quently connect to the •...
ENGLISH Before opening the door: 1. Press the Marche/Arrêt button to switch the appliance off. CAUTION! 2. Disconnect the mains plug from the Risk of burns! Make sure mains socket. that the water temperature 3. Open the filter flap. is not too high and the 4.
Page 49
16.2 Legend Laundry load. hh:mm Programme duration. Energy consumption. °C Temperature in the laundry. Litres Water consumption. Spin speed. Remaining moisture at the end of spinning phase. The higher is the spin speed, the higher is the noise and the lower is the remaining moisture.
Page 51
17.2 Cleaning the drain pump filter 180˚ Clean the filter regularly and, especially, if the alarm code appears on the display. 17.3 Programmes Programmes Load Product description Cotton and synthetic items. This programme 5.0 kg ensures a good washing performance in a PowerClean 59min short time.
ENGLISH Programmes Load Product description All fabrics, except woollens and very delicate 10.0 kg fabrics. Programme for rinsing and spinning. Rinçage To spin the laundry and to drain the water in 10.0 kg the drum. All fabrics, except woollens and del‐ Essorage/Vidange icate fabrics.
Page 53
My AEG Care app The software in this product contains components that are based on free and open source software. AEG gratefully acknowledges the contributions of the open software and robotics communities to the development project. To access the source code of these free and open source software components whose license conditions require publishing, and to see their full copyright information and applicable license terms, please visit: http://aeg.opensoftwarerepository.com (folder NIUS)
Need help?
Do you have a question about the LFR83B114V and is the answer not in the manual?
Questions and answers