B
S
U
h t
g
Charge Indicator Light
e
g
a r
c h
e
Témoin lumineux de charge
O
n /
v é
t i
a c
é s
/ d
v é
Display Backlight On/O
g
i n
Rétroéclairage activé/désactivé
n
i o
a t
d
a
g r
n ,
i o
Power On/O , Dimming
Mise sous/hors tension, gradation
time/alarm
heure/alarme
calendar
calendrier
week
semaine
temperature
température
Travel Rechargeable LED Lamp
CSRD300W
CSRD300W-CA
CSRD300W-SHPR
INS240784
L i
r
t o
c a
d i
n
e I
g
a r
h
C
USB
d
x
u
e
i n
m
l u
n
o i
m
T é
Charge Indicator Light
Témoin lumineux de charge
Li-ion Battery - Capacity: 2200mAh. Output Voltage: 3.7V
NOTICE:
O
h t
i g
k l
a c
B
y
l a
s p
D i
Never disassemble by yourself. Use the authorized charger only.
t i
a c
e
g
a
i r
l a
é c
r o
é t
R
Exposure of battery to open flames could cause explosion.
Do not expose the battery pack out of the temperature range 32°F
to 113°F (0°C~45°C)
m
m
D i
,
O
n /
O
e r
w
o
P
MADE IN CHINA
n s
e
s t
o r
/ h
u s
s o
e
i s
M
Pile lithium-ion - Capacité : 2 200 mAh.
Tension de sortie : 3,7 V
AVIS :
Ne jamais démonter le produit vous-même.
Utiliser uniquement le chargeur autorisé.
L'exposition de la pile à des flammes nues peut provoquer une
explosion.
Ne pas exposer la pile hors de la plage de températures entre
0 °C et 45 °C (32 °F et 113 °F)
Display Backlight On/O
FABRIQUÉ EN CHINE
Rétroéclairage activé/désactivé
Mode
Power On/O , Dimming
Set
Up
Down
mode
set
haut
bas
Mise sous/hors tension, gradation
CAUTION!
Battery Safety: This product
contains a button battery. If
swallowed, it could cause severe
injury or death in just 2 hours.
Seek medical attention immediately.
Please use coin to open battery cover.
SEE ADDITIONAL SAFETY WARNING.
ATTENTION!
Sécurité des piles : Ce produit
contient une pile bouton. En cas
d'ingestion, des blessures graves
ou la mort peuvent survenir en
seulement deux heures. Consulter
battery cover
immédiatement un médecin. Utiliser
couvercle des piles
une pièce de monnaie pour ouvrir
le couvercle de la pile. CONSULTER
L'AVERTISSEMENT DE SÉCURITÉ
SUPPLÉMENTAIRE.
ENGLISH
CONGRATULATIONS!
You've purchased the finest in natural lighting technology with your new OttLite
PRODUCT REGISTRATION FORM
Please complete the enclosed Product Registration Form and return it today by mail, or
USB
register online by going to: OttLite.com/warranty
NOTE: THIS UNIT IS FULLY ASSEMBLED
1. Remove lamp from packaging and place on a flat level surface.
2. To turn on the lamp touch the On/Off symbol, touch again to adjust brightness.
3. Adjust the shade to desired height.
4. The
symbol turns the light for the clock on/off.
5. Press the SET button to switch from °C to °F
PLEASE NOTE: This lamp will function while the USB charging cable is plugged into a
power source OR on its own internal battery. When using on battery power and the light
starts to dim, this indicates that the internal battery needs to be recharged. The RED
charging indicator in the back will turn off when the lamp is fully charged.
The Clock/Calendar has four features:
• Time, date and temperature
• Alarm with Snooze
• Birthday reminder
• Timer
To Set The Time:
• By pressing the MODE button once, the display will flash 24Hr. TIME will show at the
top of the screen indicating you are in TIME mode.
• To adjust between a 24 or 12 hour clock press the UP or DOWN button once.
• Pressing the SET button will then allow you to set the time and date. When the number
you want to change is flashing you can adjust it by pressing the UP or DOWN key.
• Press the SET button to move to the next item you wish to change.
• When finished press the MODE button four times to return to time and date display.
To Set The Alarm:
• Press the MODE button twice, ALARM will appear at the top of the screen indicating
you are in alarm mode.
• Press SET and the hour will start to flash. Press UP or DOWN to set the hour.
• Press SET again to select minutes and use the UP or DOWN buttons to adjust the minutes.
• Press SET again to select the alarm tone, using the UP or DOWN buttons to change tone.
• When finished, press the MODE button three times to get back to time and date display.
To Turn Off The Alarm:
• Press the MODE button twice, ALARM will appear at the top of the screen indicating
you are in alarm mode.
• Press "SET" until the screen displays • : • • and no numbers.
• Then press "Mode" 3 times to get back to the home screen.
NOTE: The clock will revert to time mode automatically in one minute if no other
buttons are depressed.
To Turn the Snooze Function On/Off:
• Press the UP button to turn on Snooze while in TIME mode.
• To turn SNOOZE mode OFF, press the UP button twice.
NOTE: SNOOZE will be displayed to indicate Snooze Function is ON.
NOTE: When alarm is sounding pressing the DOWN button will activate SNOOZE for 4
minutes.
To Set the Birthday Reminder:
• Press the MODE button three times and then press SET to change the time/date
the same way you would adjust the time and date. When active, the lamp will play a
birthday tune for 5 minutes.
• When finished, press the MODE button twice to return to time and date display.
To Set the Countdown Timer:
• Press the MODE button four times and TIMER will appear at the top of the screen.
• Press SET and the hour will start to flash, use the UP or DOWN buttons to change the hour.
• Press SET again to select minutes and use the UP or DOWN keys to change the minutes.
• Press SET again to start the countdown timer.
• To stop alarm when countdown is finished, press any button.
NOTE: By pressing the DOWN button the lamp will play music. There are 7 pre-
programmed tunes.
Clock Battery Replacement
• This lamp uses a CR2032 3V button cell battery to power the clock.
• To remove/install button cell battery: use a coin to rotate battery cover and remove.
• Once battery cover has been removed, push battery upward to remove battery. CR2032
3V button cell battery is to be installed with the "+" or flat side facing upward.
• Once new battery is installed, replace battery cover using coin to tighten.
Q20
Travel Rechargeable LED Lamp
SAFETY WARNING:
®
product.
CAUTION: DO NOT INGEST BATTERY; CHEMICAL BURN HAZARD!
•
• Remove and immediately recycle or dispose of used batteries according to local
regulations and keep away from children. Do NOT dispose of batteries in household trash
or incinerate. Even used batteries may cause severe injury or death.
• Call a local poison control center for treatment information.
• Non-rechargeable batteries are not to be recharged.
• Do not force discharge, recharge, disassemble, heat above 158 °F (70°C), or incinerate. Doing
so may result in injury due to venting, leakage or explosion resulting in chemical burns.
• Ensure the batteries are installed correctly according to polarity (+ and -).
• Do not mix old and new batteries, different brands or types of batteries, such as alkaline,
carbon-zinc or rechargeable batteries.
• Remove and immediately recycle or dispose of batteries from equipment not used for an
extended period of time according to local regulations.
• Always completely secure the battery compartment. If the battery compartment does not close
securely, stop using the product, remove the batteries, and keep them away from children.
NOTE: Coin/button cell batteries are small, single cell devices having a diameter greater
than their height.
SAFETY WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS
1. Turn lamp off and WAIT UNTIL LAMP HEAD IS COOL before handling.
2. The LED panel might get hot after several hours of continuous use DO NOT place your
hands directly on LED light panel.
3. The lamp head included with this unit cannot be replaced by the consumer.
4. INDOOR USE ONLY.
NOTE: The important safety instructions appearing in this instruction sheet are not meant
to cover all possible conditions and situations that may occur. It must be understood that
common sense, caution, and care must be used with any electrical product.
CAUTION!
THE LIGHT SOURCE OF THIS LUMINAIRE IS NOT REPLACEABLE;
WHEN THE LIGHT SOURCE REACHES ITS END OF LIFE THE WHOLE LUMINAIRE SHALL
BE REPLACED.
CAUTION: Any change or modification to product not expressly recognized by OttLite
Technologies voids OttLite's responsibility for proper function of product.
FCC PART 15
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that the interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications of this product is not expressly approved by the party responsible
for compliance and could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
CAN ICES-005 (B)/NMB-005 (B)
Specifications
USB: 5V, 1A / Input power: 5V, 1A
Battery: Lithium, 3.7V / 2200mAh (power for LED Lights)
Power for calendar: Button cell CR2032 / 3V
Accessories:
• USB charging cable
REV020224
Need help?
Do you have a question about the CSRD300W and is the answer not in the manual?
Questions and answers