QTY. One Pump Remote NOTE: The remote cradle may also be installed using the One Pump Remote Cradle supplied adhesive strip #8 1/2” Screw Adhesive Strip 1. Locate a suitable area with a flat surface to mount the remote cradle Lanyard 2.
Page 3
CRADLE INSTALLATION PAIRING & PROGRAMMING IMPORTANT! New remotes must be paired to the HPU. WARNING! Before installing the self tapping 1. Press and hold the PROGRAM button on the top of screws, inspect the area beneath the the HPU for 3 seconds (LED will turn GREEN/HPU mounting surface to ensure that the will beep).
Page 4
The LED lights will indicate speed setting. Double tap either the Up or Down Button. The anchors will automatically run until stowed or deployed. NOTE: Down Auto mode can be changed to a single tap via the Power-Pole App. Slow Medium Fast...
Page 5
BATTERY REPLACEMENT BATTERY REPLACEMENT BATTERY REPLACEMENT SPEED CONTROL STOW & DEPLOY IMPORTANT! Ensure the switch and the surrounding area is as dry as Circuit Board possible to avoid any moisture intrusion before changing the Rear Shell battery in the controller. 1.
COMPLIANCE STATEMENTS COMPLIANCE STATEMENTS FCC Part 15.19 Warning Statement Canada. To reduce potential radio interference to other users, the antenna type and its gain THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL that necessary for successful communication.
Need help?
Do you have a question about the ONE PUMP REMOTE and is the answer not in the manual?
Questions and answers