Beacon RATIO BOLLARD Installation Instructions Manual

INSTALLATION INSTRUCTIONS - RATIO BOLLARD
WARNING! Fixtures must be grounded and installed in accordance with the National Electrical Code and all local codes. Failure to do so may increase
the RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE AND DEATH. Install and use so fixture failures do not cause a hazard and use only in
environments for which the product is specifically marked.
WARNING! This product contains chemicals known to the State of California to cause cancer, birth defects, and/or other reproductive harm. Thoroughly
wash hands after installing, handling, cleaning, or otherwise touching this product.
WARNING! Dangerous voltage exist within the unit and all precautions usually observed in handling high voltage equipment should be observed when
replacing light engine or otherwise servicing luminares. Disregarding this warning could result in electrical shock and possible injury to the individual
installing or servicing this equipment. Installation and servicing should be done by qualified personnel.
CAUTION! Follow ALL luminaire recommendations, product markings, instructions, restrictions and warnings regarding luminaire operation and burning
position. Luminaire label shows electrical and environmental requirements and restrictions.
NOTE! This luminare is designed for outdoor lighting applications with ambient temperatures not exceeding 40°C (104°F).
All electrical work must be done by a qualified electrician.
Turn off electric power to all affected circuits and allow to cool before installation or servicing.
A regularly scheduled maintenance program should be established to retain optimum light output and reduce heat retention. Dusting with a soft, clean,
dry cloth is normally sufficient for the optical system. Any accumulation of dust or dirt should be removed regularly.
Carefully read these instructions before installing product. If you do not understand these instructions, before starting any work, contact your Hubbell
Lighting distributor or techsupport@hubbell-ltg.com or (864) 678-1000
Give instructions to facility owner/manager for future reference.
RATIO BOLLARD INSTALLATION PREPERATION
Tools Required:
Electrical wiring tools
#4 Phillips Head Screwdriver
9/16 Socket with Ratchet
•
Turn off power to electrical connections.
•
Wiring must be performed by a qualified electrician.
•
Make electrical connections according to the local and National
Electrical Codes .
The assumption has been made that the anchor bolts have been set in
concrete and the level pad surface has been prepared with the conduit
stub protruding from the center.
The RBD Ratio Bollard consists of three basic assembly units; the Top
Assembly (Fig1.Item1), the Post Extrusion (Fig1.Item2) and the Base
Casting (Fig1.Item3)
NOTE:
If the product you ordered was the Distribution Selectable (DS) model,
and you wish to custom select the distribution, the Top Assembly will
need to be removed to access the selector switch (see sheet 3). All other
models have fixed light distributions and the removal of the top assembly
is not necessary for installation.
93148097 Rev. B
701 Millennium Boulevard Greenville, SC 29607 (864) 678-1000
SAVE THESE INSTRUCTIONS
READ THOROUGHLY BEFORE INSTALLATION
FIGURE 1
1
2
3
www.beaconproducts.com
SHEET 1 OF 4