Table of Contents
Advertisement
Quick Links
Pressure
sensor
Original operating manual
Version
BA-2022.03.24 EN
Print-No.
300 196
TR MA DE Rev003
Pump series
PTM-C2 / tinyPTM-C2
STÜBBE GmbH & Co. KG
Hollwieser Straße 5
32602 Vlotho
Germany
Phone: +49 (0) 5733-799-0
Fax: +49 (0) 5733-799-5000
E-mail:
contact@stuebbe.com
Internet:
www.stuebbe.com
Subject to technical modifications.
Read carefully before use.
Save for future use.
Advertisement
Table of Contents
Summary of Contents for Stübbe Pump Series
- Page 1 Pressure sensor Original operating manual Pump series PTM-C2 / tinyPTM-C2 Version BA-2022.03.24 EN STÜBBE GmbH & Co. KG Print-No. 300 196 Hollwieser Straße 5 TR MA DE Rev003 32602 Vlotho Germany Phone: +49 (0) 5733-799-0 Fax: +49 (0) 5733-799-5000 E-mail: contact@stuebbe.com...
-
Page 2: Table Of Contents
Table of contents Table of contents List of figures About this document ....... Target groups . -
Page 3: About This Document
About this document About this document Other applicable documents This manual: • is part of the equipment To download: Resistance lists • applies to all series referred to Resistance of materials used to • describes safe and proper operation during all operating chemicals phases www.stuebbe.com/pdf/300051.pdf... -
Page 4: Warnings And Symbols
About this document Warnings and symbols Symbol Meaning • Immediate acute risk • Death, serious bodily harm • Potentially acute risk • Death, serious bodily harm • Potentially hazardous situation • Minor injury • Potentially hazardous situation • Material damage Safety warning sign Take note of all information highlighted by the safety warning... -
Page 5: General Safety Instructions
General safety instructions General safety instructions 2.2.2 Obligations of personnel Only complete work on the device if the following requirements are met: The manufacturer accepts no liability for damages caused • System is empty by disregarding any of the documentation. •... -
Page 6: Layout And Function
Transport, Storage and Disposal Layout and Function Transport, Storage and Disposal Type plate Unpacking and inspection on delivery 1. Unpack the device when received and inspect it for trans- P T M C2 port damage and completeness. D r u ck sensor 2. -
Page 7: Disposal
Installation and connection Disposal 3. Weld device insert to the process pipework spool piece. 4. Check O-ring fitting. Plastic parts can be contaminated by poisonous or radioac- 5. Connect device to the process pipework. Tighten union nut tive media to such an extent that cleaning will not be suffi- by hand only. -
Page 8: Electrical Connection Of Device
Maintenance Electrical connection of device Servicing Device is connected to the process pipework. Interval Action Power supply switched off and secured against being As necessary • Clean device with a damp cloth. switched back on again. Six-monthly Visual and function check: Cable without shielding can be used to connect the device. -
Page 9: Troubleshooting
Appendix Troubleshooting WARNING Risk of injury and poisoning due to hazardous media liq- uids! Use personal protective equipment when carrying out any work on the device. Error Possible cause Corrective action Medium escaping at process Retighten union nut by hand. Pre-tension of the O-ring too connection (PTM-C2) small...
Need help?
Do you have a question about the Pump Series and is the answer not in the manual?
Questions and answers