Merit 63501 Manual

ITEMNO.:63501
PLEASE READ BEFORE OPERATION!
* Tools recommended as below: (Not included)
Adhesives; Paints; Side Cutters; Sharp Edged Pliers; Modeling Knife; Modeling
File; Nippers; Drill; Scissors; Sand Paper; Soft Cloth; Cyanoacrylate Glue.
* Make sure to read this instruction listed below before assembling.
* The kit contains the small parts, they can be dangerous if swallowed by mistake,
so keep them away from reach of children.
* Cut the all parts off carefully and remove the waste parts into the garbage can.
* More caution and care should be needed for cutting and handling the photo
etched parts.
* Make attention that some parts should be attached the decal when assembled.
* During assembling, please tear up and throw away the plastic bags, or may cause
the dangerous if wearing over head by children's mistake.
* When using the adhesives and paints, please do not use them in the closed room
or near the fire, also must be very careful to protect your eyes.face and clothes.
* Adult supervised when assembled by children under 14 years old.
* ;
The method to apply the decals
1 .Cut off the decal from the decal paper and put it into the
warm water 40 C for 10 seconds.
2.Take the decal from the water and put it on a piece of clean
cloth.
3. Remove the decal slowly from the paper to the targeted
location by a wet finger.
4.Use a piece of dry and soft cloth to press it gently on the
decal until it getting dry and no bubble existing.
KU
Cyanoacrylate glue Weight
S*¥ WfcR*
Option File/Sand No cement
ap* ajL usat
Bend Cut/Remove Make hole Decal
63501