Advertisement
Gas Griddle Models
EGG-16S
EGG-24S
EGG-36S
EGG-48S
EGG-60S
Please read this manual completely before attempting to install or
operate this equipment. Notify carrier of damage! Inspect all
components immediately.
©2024 Empura Equipment
Gas Griddles
EGG-16ST
EGG-24ST
EGG-36ST
EGG-48ST
EGG-60ST
www.Empura.com
Service, Installation &
Care Manual
EGG-36S
EMG-12
EMG-24
EMG-36
EMG-48
EMG-60
1
v1-1-24
Advertisement
Table of Contents
Summary of Contents for Empura Equipment EGG-36S Series
- Page 1 EGG-16ST EMG-12 EGG-24S EGG-24ST EMG-24 EGG-36S EGG-36ST EMG-36 EGG-48S EGG-48ST EMG-48 EGG-60S EGG-60ST EMG-60 Please read this manual completely before attempting to install or operate this equipment. Notify carrier of damage! Inspect all components immediately. www.Empura.com ©2024 Empura Equipment v1-1-24...
-
Page 2: Table Of Contents
• The equipment must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or www.Empura.com ©2024 Empura Equipment less than ½ psi (3.5 kPa). v1-1-24 Clearance and positioning around the equipment: •... -
Page 3: Positioning & Gas Conversion
2. Set the regulator to 10” W.C. by inverting the regulator spring plug like below pictures 1. Remove all natural gas burner orifices and install the provided propane burner orifices. 2. Set the regulator to 10” W.C. by inverting the regulator spring plug like below pictures www.Empura.com ©2024 Empura Equipment v1-1-24... -
Page 4: Pilot Lighting & Burner Adjustments
OPERATION: www.Empura.com ©2024 Empura Equipment Before initial use, turn the gas control knob to the maximum setting and allow the equipment to v1-1-24 burn-in for 20 minutes. -
Page 5: Operation, Seasoning & Cleaning
Rub with the grain of the metal while the griddle is still warm (not hot). A detergent may be used on the plate surface to help clean it, but be sure the detergent is thoroughly removed by www.Empura.com ©2024 Empura Equipment v1-1-24 flushing with clear water. -
Page 6: Once Per Week & Leveling
2. Adjust legs by turning the bullet feet at the bottom of each leg. Using pliers or a crescent wrench, turn the feet counter-clockwise to increase height, and clockwise to decrease height until leveling is achieved. Do not extend the legs more than 1-¾”. www.Empura.com ©2024 Empura Equipment v1-1-24... -
Page 7: Trouble Shooting
3. Too much griddle fat off-flavor used. 4. Temperature was set too low. 1. Temperature was set too high. 2. Griddle surface Noticeable build-up of gum on griddle needs cleaning and/or seasoning. 3. Too much griddle fat used. www.Empura.com ©2024 Empura Equipment v1-1-24... -
Page 8: Specifications
Propane Gas 10.0" W.C. 4 Burners w/ Natural Gas 4.0" W.C. EMG-48 EGG-48ST individual control 120,000 Propane Gas 10.0" W.C. 5 Burners w/ Natural Gas 4.0" W.C. EGG-60ST 150,000 EMG-60 individual control Propane Gas 10.0" W.C. www.Empura.com ©2024 Empura Equipment v1-1-24...
Need help?
Do you have a question about the EGG-36S Series and is the answer not in the manual?
Questions and answers