Sub-Zero 7002137 Configuring Manual

CONTAINS:
TO AVOID ELECTRICAL SHOCK, DISCONNECT ELECTRICAL POWER TO EQUIPMENT WHEN ATTEMPTING
THIS REPAIR.
NOTE: This main control board is used in several different models. It must be configured/programmed for the specific
model it is used in by a series of key strokes at the control panel. This is referred to as Model Configuration.
AUTOMATIC ENTRY MODEL CONFIGURATION MODE:
When this control board is first installed and power is supplied to the appliance, double dashes (- -) will appear in the
LCD (See Figure 1).
Configure the board for the specific model by following the steps below:
1. Toggle through model codes by pressing WARMER or COLDER keys, until appropriate model code is displayed
(See Figures 2 and 3, also the Model Code Table).
2. When appropriate model code is displayed, press POWER key to store model configuration (See Figure 4).
Figure 1. "- -" Double Dashes when New Board Installed = Model Configuration must be Performed
Service Board Configuring Instructions
QTY
1
1
Figure 2. Press WARMER or COLDER key to Toggle Through Model Codes
Figure 3. Stop When Appropriate Model Code is Displayed
Figure 4. Press POWER key to Store Model Configuration
7002137
DESCRIPTION
Electronic Control / Control Assembly
Instruction Sheet
Page 1 of 2 7002693 / Rev A / April, 2009