STROBES N MORE E3DC Installation Manual

INSTALLATION GUIDE
Strobes N' More E3DC LED Lighthead
Safety First! Before beginning the installation and/or operation of your LEDs, the installation technician and operator
must read this manual in full, before installation. This document provides all the necessary information to allow your
E3DC to be properly and safely installed to prevent severe injury or damage.
Proper installation of this product requires the installer to have a good
understanding of automotive electronics, systems and procedures. Do not stare
directly into these lights. Momentary blindness and/or eye damage could result.
Do not install this product or route any wires in the deployment area of your air
bag. Equipment mounted or located in the air bag deployment area will damage
or reduce the effectiveness of the air bag or become a projectile that could cause
serious personal injury or death. Refer to your vehicle owner manual for the air
bag deployment area. The User/Installer assumes full responsibility to determine
proper mounting location, based on providing ultimate safety to all passengers
inside the vehicle. If this product uses a remote device to activate or control this
product, make sure that this control is in an area that allows both the vehicle and
the control to be operated safely in any driving condition. Do not attempt to
activate or control this device in a hazardous driving situation.
Flash Pattern Selection
Select Flash Patterns by applying BLUE wire to + 12 Volts Positive
• 1 second short touch for FORWARD pattern; repeat until desired pattern is found
• 1~3 seconds for PREVIOUS pattern
• 3~5 seconds for steady burn
• 5+ seconds to turn-off
Sync Wire – Sync two or more lightheads to same flash pattern
All lights must be set to the same flash pattern before connecting yellow wires to any lighthead.
Watch our helpful installation videos:
WARRANTY Provided this product is installed and operated in a manner consistent with its use, Strobes N' More guarantees its E-Series LED
lightheads for a period of 5 years from the day of purchase. Units demonstrated to be defective within the warranty period will be repaired or
replaced at the seller's discretion. The customer is responsible for shipping the item to Strobes N' More - we will cover the cost of return
shipping. International customers are responsible for all shipping charges. Improper installation or use of inappropriate or inadequate wiring or
circuit protection causes the warranty to be void. Applying voltage directly to the LEDs will cause immediate failure and void the warranty.
Damages resulting from improper use and/or accidents are not covered by this warranty. Aluminum will corrode if left in the elements or area
of high road salt use – clean accordingly. Use of non-compatible components and assemblies may cause damage to the system and/or personal
injury and voids all warranties. Strobes N' More LLC shall in no way be liable for other damages including consequential, indirect or special
damages whether loss is due to negligence or breach of warranty. Visit
If mounting this product requires drilling holes, the installer must be sure that no
vehicle components or other vital parts could be damaged by the drilling process.
Check both sides of the mounting surface before drilling begins. Also, de-burr any
holes and remove any metal shards or remnants. Install grommets into all wire
passage holes. For this product to operate at optimum efficiency, a good
electrical connection to chassis ground must be made. The recommended
procedure requires the product ground wire to be connected directly to the
NEGATIVE (-) battery post or vehicle chassis. Do not attach the NEGATIVE (-) wire
to any other existing ground wire. It is recommended that these instructions be
stored in a safe place and referred to when performing Maintenance and/or re-
installation of this product. FAILURE TO FOLLOW NSTRUCTIONS COULD RESULT IN
DAMAGE TO THE PRODUCT OR VEHICLE AND/OR SEVERE INJURY TO YOU AND
YOUR PASSENGERS!
https://www.strobesnmore.com/install-videos
www.StrobesNMore.com/warranty for more information.