Water Softening System; Overview Of Water Hardness Settings; Setting The Water Softening System; Special Salt - NEFF S153ITX02G Information For Use

10.2 Setting the water soften-
ing system
Set the water hardness on your appli-
ance.
Determine the water hardness and
1.
the appropriate setting value.
→ "Overview of water hardness set-
tings", Page 22
Press ⁠ .
2.
To open the appliance settings,
3.
press
flashes.
a
Press repeatedly until the
4.
right water hardness has been set.
A
0, 1, 2 or 3 LEDs will light up ac-
cordingly.
→ "Overview of water hardness set-
tings", Page 22
The factory setting is level 1 (LED
A → Page 15).
To save the settings, press
5.
for 3 seconds.
10.3 Special salt
You can use special salt to soften
water.
Adding special salt
If the special salt refill indicator lights
up, add special salt to the dispenser
for special salt just before the pro-
gramme starts. The consumption of
special salt depends on the water
hardness. The higher the water hard-
ness, the greater the consumption of

special salt.

for 3 seconds.
B C
Water softening system en
ATTENTION!
Detergent may damage the water
softening system.
Only fill the dispenser of the water
▶
softening system with special dish-
washer salt.
Special salt for dishwashers can
damage the tub due to corrosion.
To make sure that any special salt
▶
that escapes is washed out of the
tub, add the special salt to the dis-
penser for special salt immediately
before the programme starts.
Unscrew the lid of the dispenser
1.
for special salt and remove.
On initial start-up: Fill the dispenser
2.
right up with water.
Note: Only use special salt for
3.
dishwashers.
Do not use salt tablets.
Do not use table salt.
Add the special salt to the dis-
penser.
Fill the dispenser right up with spe-
cial salt. The water in the dis-
penser is displaced and forced
out.
Place the lid back on the dis-
4.
penser and turn to close.
23