GENERAL INFORMATION The PumpSpy 12 Volt Battery Backup System is designed to automatically remove water from a sump pit during a power outage or if the primary sump pump fails to operate properly. It is not intended as a long term replacement for a primary sump pump.
WARNING RISK OF EXPLOSION. TO REDUCE THIS RISK, OBSERVE THE FOLLOWING WARNINGS: • Do not use to pump flammable or explosive liquids such as gasoline, fuel oil, kerosene, etc. • Do not use in a flammable or explosive atmosphere. WARNING NOT SUITED FOR POTABLE WATER APPLICATIONS.
SYSTEM OPERATION The PumpSpy 12 Volt Battery Backup System is an automatic system and will automatically operate during a power outage or when the primary sump pump fails to operate. The System automatically maintains and recharges the battery. The PumpSpy 12 Volt Battery Backup System performs a full system test every day.
Page 5
USING THE CONTROLLER BUTTONS The PumpSpy 12 Volt Battery Backup System features two push buttons on the controller. The PUMP TEST button activates the backup pump. The pump will continue to run as long as the button is pressed. Do not run the backup pump in a dry sump pit for extended periods.
Page 6
MESSAGES The PumpSpy 12 Volt Battery Backup System displays Informational and Alarm messages on the Message Center. Informational messages do not require immediate attention and do not sound an alarm. If more than one message is active, they rotate on the display.
(the “Warranty Period”). During the warranty period, PumpSpy will repair or replace at no cost to you, to correct such defects in products found upon examination by PumpSpy to be defective in materials or workmanship.
Need help?
Do you have a question about the PS1200 and is the answer not in the manual?
Questions and answers