Download Print this page

Snug Cottage Hardware Borg Locks BL2625-ECP Installation Manual, Parts List & Maintenance Instructions

Download this manual

Installation Guide, Parts List and

Parts List:

Neoprene Seals x 2

Mortised Lock Keep

Surface Lock Keep x 2

Mortised Lock Keep

BL2625-ECP

Maintenance Instructions

Factory Pre-Set

Code Card

Wood Screws x 8

Wood Screws x 4

Tweezers x 1

Hexagonal Shaft x 2

2-3/8" (60mm)

Code Change Key

for Recoding

Need help?

Do you have a question about the Borg Locks BL2625-ECP and is the answer not in the manual?

Page 1 BL2625-ECP Installation Guide, Parts List and Maintenance Instructions Parts List: Factory Pre-Set Code Card Wood Screws x 8 Wood Screws x 4 Tweezers x 1 Neoprene Seals x 2 Hexagonal Shaft x 2 2-3/8” (60mm) Mortised Lock Keep Code Change Key for Recoding Surface Lock Keep x 2 Mortised Lock Keep...
Page 2: Before Commencing Installation
Before Commencing Installation Please check that all parts are working correctly. Per the Factory Pre-Set Code Card provided, press the code into the lock and then turn the knob. It should turn easily under spring pressure. If you intend to change the code, you can do it before or after installation, please refer to the How to Change your Code instructions provided below.
Page 3 Please note, if the On The Door Code Change Deactivation Plug is inserted/fitted to the back of the push button keypad, the code will not be able to be changed as described previously in these instructions. If at a later date the On The Door Code Change Function is required, the keypad will need to be removed from the lock body and the deactivation plug taken out.
Page 4 Changing the Handing of Lock (Table 4A) Installation Exploded View (Table 5A)
Page 5 These procedures can be carried out as needed when lock is sticky or code is accepted intermittently. If you experience any problems when installing this lock, or changing the code please contact: Snug Cottage Hardware Marysville Michigan, USA and London, Ontario, Canada 1-800-637-5427...