Page 2
STOP! An Oxford Nanopore Technologies Engineer will unpack and install your device. You should not unpack or install your PromethION™ 24 Combined. This Quick start guide will tell you everything you need to do to check your hardware before you start sequencing following your device installation by an Oxford Nanopore Technologies Engineer.
Power on your PromethION 24 Combined Important: Power on your device precisely following the steps below. Refer to the device diagram on page 6 of this Quick start guide to help locate the power switches on the device units. Turn on the power at the mains socket (if present) and then toggle the power switch at the rear of the Sequencing Unit.
Page 4
Your PromethION must be shut down according to the steps below to prevent potential device errors. Please place the Powering on and off your PromethION 24 Combined flyer that accompanies this Quick start guide next to your PromethION device to support other users.
Oxford Nanopore is committed to environmental sustainability. You can help by sending your flow cells for recycling. Find out how: community.nanoporetech.com/support/returns Place your next order Buy more consumables at the Oxford Nanopore Store: store.nanoporetech.com Documentation Documentation for your device is available on the Nanopore community.nanoporetech.com/docs...
Page 6
Combined Data Acquisition Unit Sequencing Unit Device connections 10G Ethernet ports Power on/off USB-B port - Data Acquisition Unit USB-Mini ports Fibre module cages USB-A ports 10. Mini DisplayPorts USB-C port VGA port Power sockets Power on/off - Sequencing Unit...
Technical specification PromethION 24 Combined Model number PRO-CMB024 Data Acquisition Unit Device units Sequencing Unit 220-240 AC ± 10% Supply voltage (V) 100-240 AC ± 10% (50/60 Hz) (50/60 Hz) 12-11 A (220-240 VAC) Maximum rated current (A) 2200 Maximum rated...
Need help?
Do you have a question about the Promethion 24 and is the answer not in the manual?
Questions and answers