Explore Planet Earth Bellbird Pitching Instructions

Model No. BEL8MTOR
Pitching Instructions
Your Tent Includes:
1 x STEEL centre pole
2 x STEEL door poles
1 x Door A bend
26 x pegs
19 x ropes
1. Select a dry, level site and clear the ground of any sharp objects.
Remove the tent from its carry bag and unroll the tent in your selected
location.
2. Spread out the floor of the tent and peg out all points ensuring that
the tent is pulled taut. Unzip and open the door to make erecting the
tent easier.
To make sure the
tent stays in place,
insert the pegs into
the ground at a 45°
angle.
3. Assemble the main/centre pole by interlocking the sections
together, ensuring that each end of the pole has an end cap.
Thread the pole through the main door. Place the top end cap into
the reinforced centre of the tent roof. Slowly walk the pole into the
centre of the tent while pushing up on the pole. Stop when the pole
is fully vertical and lever in to the centre of the tent. Locate base of
pole in floor pocket.
4. Inside the tent, assemble the remaining poles into an A frame for
easier installation. Insert the top pin on the A frame and bend
through the eyelet at the top of the door opening.
Secure the A frame leg
ends into the pockets
on the tent floor on
either side of the
entrance.
5. Peg out all the guy ropes and ensure they are taut.
Reverse the procedure to lower the tent
Packing Instructions
Pack the poles and pegs into their bags. Evenly layout the fly leaving
the door open. Fold the tent floor from each end to the centre. Fold
again to the width of the tent bag. Place the tent pole and peg bags
at the end of your folded tent. Roll from back to front, forcing all of the
air out the front door. Roll into the tent bag provided.