Advertisement
Advertisement
Table of Contents
Related Manuals for Sanela NEMO
Summary of Contents for Sanela NEMO
- Page 1 NEMO - MAINS POWER Installation & maintenance instructions.
- Page 2 General Information • Designed for indoor use only. Do not expose to elements of nature. • All plumbing and electrical connection must be made in accordance with AS/NZS standards. Warnings • Read all instructions before attempting to install this system. It is recommended a qualified &...
-
Page 3: Specifications
Failure to comply with instructions could result in personal injury and/ or property damage. Retain instructions for future reference. Sanela Nemo Sensor Tap Sensor activated tapware where cold & hot water is regulated by an integrated thermostatic mixer. High quality electronics combined with elegant aesthetics, designed for the medical industry. -
Page 4: Standard Functions
Components Plate covers x 2 Faucet body x 1 Swivel arm x 1 Brass connectors x 2 Standard Functions Person comes within Person leaves active active range, water range, water stops flows Automatic shut off Active range Operating pressure range 0.3 - 0.75 after 5mins splwashrooms.co.nz... -
Page 5: External Power Supply Installation
External Power Supply Installation Input 230V / 50 Hz 24 V DC Output IP rating IP 55 5°C - 40°C Operating temperature Rated power 10W 24V output (to faucet) 230V input Important To be installed in accordance with all NZ electrical regulations. It must be carried out by a qualified professional. - Page 6 Drill and insert appropriate wall anchors if required Remove cover from mounting box Pass mains (230V) power supply into mounting box Fix mounting box to wall via grommet and terminate accordingly Note: Power supply should be secured via current breaker before the external supply (not included) Reinstall cover of mouting box and ensure sealed.
-
Page 7: Faucet Installation
Faucet Installation Fit off brass connectors directly to mains water Prepare the wall for hot and cold water connectors and power connection supply and ensure equal pressure between hot and cold Unscrew security screw from bottom left of faucet Fit cover plates over brass connectors, being sure to body to release the end cap pull power cable through designated hole on cover plate... - Page 8 Connect external power (24V outlet) supply to wago Replace end cap and secure security screw connectors on faucet (Note polarity: brown to brown, white to white) Do not come within active range Fit swivel arm on the faucet body and tighten securely.
- Page 9 Important • Ensure hot and cold water pressure is equal for thermostat to operate correctly. • Pipework is required to be flushed thoroughly prior to faucet and solenoid installation. Foreign debris may reduce level of flow and in some cases damage the solenoid valve. •...
-
Page 10: Maintenance
This may damage the filter of the infrared sensor and/or the finishing of the faucet. Note: If you require to modify any of the factory settings please request the Sanela remote SLD03. Sensor on / off Adjustable active... -
Page 11: Troubleshooting
Troubleshooting Symptom Possible Cause Corrective Action No water flow - a. Water supply a. Ensure water at source is LED on sensor b. Water connections b. Ensure connections flashing red when c. Clean filter (angle valve c. Filter is clogged hands are within d. - Page 12 Supreme Comprehensive Warranty Your Supreme sensor tap is fully guaranteed against defective materials and faulty workmanship commencing from the date of sale (according to SPL’s records), subject to it being installed and maintained in accordance with the manufacturer’s instructions. SPL (2021) Limited warrants that should any part of the sensor tap fail within the given warranty period (24 months), it will be remedied by SPL.
Need help?
Do you have a question about the NEMO and is the answer not in the manual?
Questions and answers