Congratulations on purchasing your Russell Hobbs Cora hair dryer. Each unit is manufactured to ensure safety and reliability. Before using this appliance for the first time, please read the instruction manual carefully and keep it for future reference. FEATURES OF THE RUSSELL HOBBS CORA HAIR DRYER •...
Page 3
Incorrect operation and improper use can damage the appliance and cause injury to the user. The appliance is intended for household use only. Commercial use invalidates the warranty and the supplier cannot be held responsible for injury or damage caused when using the appliance for any other purpose than that intended. Avoid any contact with moving parts.
15. Do not allow the cord to touch hot surfaces and do not place on or near a hot gas or electric burner. 16. Use of an extension cord with this appliance is not recommended. However, if it is necessary to use an extension cord, ensure that the cord is suited to the power consumption of the appliance to avoid overheating of the extension cord, appliance or plug point.
Page 5
the electrical circuit supplying the bathroom. Ask your installer for advice. • WARNING: Do not use this appliance near bathtubs, showers, basins or other vessels containing water. Should the hair dryer be used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the hair dryer is switched off.
• This device has an overheating protection system. In the event of overheating, (if the air inlet or air outlet is covered) the device will automatically switch off. If this occurs, set the on/off switch to 0 (off), pull out the plug from the mains socket, and allow the device to cool down adequately.
Page 7
6 67 1. Styling concentrator (rotatable and removable) 2. Removable rear grille 3. Cool shot button 4. 3 Heat settings 5. 2 Speed settings 6. Hanging loop 7. Diffuser OPERATING INSTRUCTIONS NOTE: Before using for the first time, switch the device on for a few minutes and allow it to run at the highest speed and temperature settings.
Page 8
The switches for hot air and speed settings allow you to select the desired temperature and the air flow: low heat = Off = low air flow medium heat = strong air flow high heat Cooling function: After styling your hair with the higher temperature of the unit, the cool shot function can be used to improve the durability of the style created.
HINTS AND TIPS • As a general guide use higher heat / speed settings for initial drying, rough drying as well as for thicker, heavier hair. Use lower settings for finer hair, to complete your style and for more precise control. •...
the hair dryer with the air inlet facing downwards. Clean the inside and outside of the removable grille with a brush. • If you have long hair or use high amounts of styling products, clean the filter regularly at least once a month. STORING THE APPLIANCE •...
Page 11
• Proof of purchase is attached. • A reason is provided for why it is being returned. If the supply cord is damaged, it must be replaced by the manufacturer or an authorised service agent, in order to avoid any hazard. If service becomes necessary within the warranty period, the appliance should be returned to an approved Home of Living Brands (Pty) Limited service centre.
CHANGING THE PLUG Should the need arise to change the fitted plug, follow the instructions below. This unit is designed to operate on the stated current only. Connecting to other power sources may damage the appliance.
Page 13
PLEASE AFFIX YOUR PROOF OF PURCHASE/RECEIPT HERE IN THE EVENT OF A CLAIM UNDER WARRANTY THIS RECEIPT MUST BE PRODUCED. 1 YEAR STANDARD WARRANTY Warranty will be extended for another year if you register your product online within 12 months of purchase (visit https://russellhobbswarranty.co.za/ W A R R A N T Y AND EXTENDED WARRANTY...
Page 14
or on behalf of the customer, then the supplier may replace the product or pay a refund to the customer, subject to the supplier’s discretion. The customer may be responsible for certain costs where products returned are not in the original packaging, or if the packaging is damaged.
Need help?
Do you have a question about the RHHD17 and is the answer not in the manual?
Questions and answers