Hioth CT-EDZB4002-HM User Manual

Temperature and humidity sensor

Advertisement

Temperature and humidity Sensor
This product is an intelligent temperature humidity detector, Using the ultra-low power,
ZigBee wireless network technology, the product stability is guaranteed from the design. The
MCU microprocessors are also used for intelligent processing of temperature and humidity signals.
Built-in high-precision temperature and humidity sensors can be used in real-time to feel the
temperature humidity to the APP. The products are applicable to the environment monitoring in
residential, workshop, machine room, shopping mall, hotel office, teaching building, bank, library
and warehouse. Easy to install.
Compatible with ZigBee network controller
Battery powered and
HIOTH TECHNOLOGY CO.,LTD.
HIOTH
Introduction
Technical Information
cost savings
User Manual
CT-EDZB4002-HM
Temperature and humidity Sensor

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CT-EDZB4002-HM and is the answer not in the manual?

Questions and answers

Summary of Contents for Hioth CT-EDZB4002-HM

  • Page 1 APP. The products are applicable to the environment monitoring in residential, workshop, machine room, shopping mall, hotel office, teaching building, bank, library and warehouse. Easy to install. Technical Information  Compatible with ZigBee network controller  cost savings Battery powered and HIOTH TECHNOLOGY CO.,LTD.
  • Page 2: Specifications

      Working Temperature: -10℃~+50℃ Working humidity: ≤95%RH   Dimension: 606020.8mm Operation As shown in figure 1, the temperature and humidity sensor has a reset button on the side, and its function is as following: Fig.1 HIOTH TECHNOLOGY CO.,LTD.
  • Page 3 Choose "FBee" to enter the Network Inclusion mode on the APP, then click " ". When prompt a message “Request Access Success”, please go to the device list interface, and refresh the device list, the device will be displayed. HIOTH TECHNOLOGY CO.,LTD.
  • Page 4: Installation Instructions

    Remove the battery Mylar film when ready to let the detector work. If there is no battery inside the detector or need to replace a new battery, please insert the battery first. Make sure The equipment is connected to the ZigBee Gateway. HIOTH TECHNOLOGY CO.,LTD.
  • Page 5 Tear down the double-sided adhesive film on the base of the mount and attach it to the appropriate area Note that the base of the installation must follow the arrows in the picture. The probe is then mounted to the mounting base. HIOTH TECHNOLOGY CO.,LTD.
  • Page 6: Safety Notice

    The working temperature is -10°C to +50°C.  Keep the device away from a strong sunlight, humidity, high temperature or mechanical shock.  Keep the device away from acid-base and other corrosive solids, liquids, gases, to avoid damage. HIOTH TECHNOLOGY CO.,LTD.

Table of Contents